The procedure is covered in your owner's manual. If you don't have one you can download a .pdf file.
disactivate the antitheft
where is black reset button umder drivers dash
You can reset your antitheft system by removing the antitheft fuse. Keep the fuse out for 10 seconds. Replace the fuse to its original slot.
A person can reset the oil change light on the Subaru Outback by turning off the vehicle and disconnecting the battery. Also, it is important to check the oil level just in case there is an issue.
The easiest way to reset the antitheft system in your 1998 Mercury is to remove the antitheft system fuse. Keep the fuse out for 10 seconds and then replace it to its original position.
how to reset the antitheft alarm system in a 1996 Chrysler town&country lxi
How do you reset the auto locks on a 1998 Subaru. Disconnected the battery to clean terminals. Now the auto lock does not work from the door switches
Were is the antitheft switch
To reset the antitheft system on an Infiniti M30 coupe, first ensure that the vehicle's battery is fully charged. Then, disconnect the battery for about 15 minutes to help reset the system. After reconnecting the battery, try using the key to unlock the driver’s door and start the car. If the issue persists, consult the owner's manual or seek assistance from a qualified mechanic as there may be a deeper issue with the antitheft system.
find the reset button under the drivers dash, its atached to two brown wires. once you've found the button turn the key on and hold the button at the same time. this will reset the system and stop the lights from flashing.
The easiest way to reset your antitheft system is to remove the fuse. Leave the fuse out for 10 seconds and then replace it to its original slot.
To reset the oil minder on a 2013 Subaru Outback, first turn on the ignition without starting the engine. Then, press the "Gas" and "Brake" pedals simultaneously three times. After that, turn the ignition off and then back on to verify that the oil change reminder has been reset. If done correctly, the oil change light should no longer be illuminated.