My dealer told me that there is a reset button under the steering column, turn the key on, hold down button till it flashes three times and release. I tried this and it did not work but the next step is to replace the valve stem cores, then the sensors themselves. good luck I hope it works for you.
How do you cancle or turn off the 2006 Toyota tundra's tire warning pressure system.? other than putting tape over the light.
An orange circle with the cross section of a tire in the middle of it.
My 2008 Tundra look something like this (?). It's a little light on the right of my dash panel.
Tire pressure warning light
To reset the low tire warning in a 2008 Toyota Tundra, first ensure that all tires are properly inflated to the recommended pressure. Then, turn the ignition to the "ON" position without starting the engine. Press and hold the tire pressure warning reset button, usually located under the steering wheel, until the warning light blinks three times, then release the button. Finally, start the engine, and the warning light should be off if the tire pressures are correct.
how do you reset the low tire pressure warning light on a 2009 camry
how do you reset the check engine light on a 2005 Toyota tundra
low tire pressure
On a 2006 Toyota Tundra, the low tire pressure reset button is typically located under the dashboard, near the steering column. It may also be found near the driver's side footwell. To reset the tire pressure warning light, make sure all tires are properly inflated, then press and hold the reset button until the light blinks and turns off.
It's a button just under the dash by your right knee. Also make sure all your tires are within 5 Lbs of each other EVEN THE SPARE or it will trigger the light to come on again.
Have you tried looking in your Owners Manual, it's in there.
How to Reset Maintenance Warning Light on a 2008 Toyota 4Runner