0
I have an '04 CR-V, and the process is explained on pg. 59 of my owner's manual under the Instrument Panel section. The 2006 owner's manual may have different page sections, but look for the Instrument Panel section under the Maintenance Required Indicator & it you should find instructions for your model.
For my 2004 model, it's done as follows:
1) Turn off the ignition
2) Push in the select/reset button (the little bar-type button to the bottom right of the speedometer in my 2004 model - I assume it's the same basic area on the 2006 model.)
3) Hold in the select/reset button as you start the vehicle, and continue to hold the button about 10 seconds or so until the light shuts off.
I do this all the time on my CR-V. Hopefully the process remained the same for the newer models & this will help you too, but if your model is different, just check your owner's manual & you'll find the instructions in there somewhere :)
Good luck!
What else can I help you with?
How do you reset check engine light for 2007 Honda crv?
You reset it with an OBD2 scan tool.
How do you reset the computer on a Honda 2006 crv?
The on-board computer is factory installed and cannot be 'reset' - it must be replaced.
How to reset seatbelt after airbag deployed crv?
YOU DONT BUT TO RESET THE LIGHT AFTER REPAIR GO TOWWW.VEHIX411.COM TO SEE FREE VIDEO INSTRUCTIONSI have a 2000 CRV and the airbag deployed which caused the seatbelts to lock. How do you reset them?
Where is the fuel pump reset switch located in the 2008 Honda crv?
There is no such reset button on your Honda CRV.
How do you reset the maintenance required light on a 2004 Honda CR-V Do you take it to the dealer This is 30K plus miles.?
How do you reset the maintenance required light on a 2004 Honda CRV Do you take it to the dealer This is 60K plus miles.?" Hold Down the trip counter button make sure it is on miles as you hold it down and have it down slowly turn on the key and that should reset it or just take the battery cable off if you don't want to go through all that.
How do you reset the maintenance required light on Honda CR-V?
use your key to push in a button in front of the dash board ( by all the guages) From the CRV 2004 Owner's Manual: Turn off the engine. Press hand hold down the reset button used to reset the milage. While holding it down, turn on the key and hold the button down for 10 seconds. The light should go off.
2006 crv PCV valve location?
location of the pvc value 2006 honda crv
How do you turn off the maintenance required light on a 2002 Honda CRV?
On 2002 at least, you have to hold for at least 30 seconds. hold the trip odometer button while turning on ignition, relase when light goes out on the 2002 you hold the trip odometer reset button while you turn the ign switch on
Reset oil change light on Honda 2008 crv?
You will find the correct procedure here: http://www.crvownersclub.com/forums/showthread.php?t=5059
What does wrench symbol on 2012 CRV mean?
The wrench symbol on a 2012 Honda CR-V indicates that the vehicle is due for scheduled maintenance. This warning light typically appears after a certain number of miles or time since the last service. It serves as a reminder to check and perform necessary maintenance tasks, such as oil changes or inspections, to ensure the vehicle runs smoothly. If the light remains on after servicing, it may need to be reset.
How do you turn off the emission ck light on a 2000 CRV Came on after the gas cap was not put back on after refueling Have filled the tank four times after the cap was replaced Light is still on?
You have to find a mechanic or someone at O"riellys or autozone who will reset the light. You have to have an OBDII (electronic computer) to reset the code light
What is the light that looks like a clock under the tachometer on a Honda crv 2005?
It shows the intrument brightness control is changed by turning the odometer reset button.
