Disconnect one cable of your battery and turn the car key to ignition position two times, connects your battery and turn the car key to ignition.
It has a chain
You will have to remove the timing belt to replace the water pump. I just had mine done on 06 kia sorento and it took the mechanic 6 hours.
I have an '07 Sorento. I have to access it through the glove box. I have an '06 Sorento 3.5 L engine. It does not have a cabin filter per technician at Kia dealership. If you have a 3.8L engine you have a cabin filter...
how do I adjust/activate 06 sorento alarm sensitivity
To open the fuel cap on a 2006 Kia Sorento, first ensure the vehicle is turned off. Locate the fuel door release lever, which is typically found on the driver's side, near the floor or the left side of the seat. Pull the lever to release the fuel door, then simply open the fuel cap counterclockwise to access the fuel tank.
Short answer is no. When the car warms up after installing the intake, take it for a drive, the mass air flow sensor will tell the computer there's more air and the computer will automatically adjust. If you reset the computer, the calibrations from all the sensors is lost and must be relearned. On some vehicles, during the relearning process, the engine may run rough and the transmission may shift harder or slip until the drive cycle is complete. Save the headache, the computer should take care of everything.
you may need to look into replacing the door jamb switch..
Reset Speed was created on 2002-06-24.
It is inside the transmission.
To reset the TPMS light on a 2006 Kia Sedona, start by ensuring that all tires are properly inflated to the recommended pressure. Next, turn the ignition to the "On" position without starting the engine. Press and hold the TPMS reset button, usually located beneath the steering wheel, until the TPMS light blinks three times, then release the button. Finally, start the engine, and the TPMS light should turn off after a few moments if the system is functioning correctly.
i don't now know
If it is the same as an 06 there are 3 bolts that hold the Headlight assembly on. One on top and 2 close together on the front close to the grille. Take these out and the assembly comes out so you can get to the cover that goes over the bulb. Check your owners manual for more details.