To remove the dash from a 1992 Toyota Paseo, start by disconnecting the battery for safety. Then, carefully remove any trim pieces and screws securing the dash, typically found around the instrument cluster and along the edges. You may need to detach the radio and climate control units as well. Finally, gently pull the dash away from the frame, ensuring all wiring connections are disconnected before fully removing it.
unscrew the screws...then pull on dash, and walaa
10-30
The proper gap for your Paseo is .043
Forget to take out the key
I believe they are styled different but will fit. I am parting out a 92 paseo and have both mirrors.
It's built into the MAF
the Toyota mr2 engine is said to fit but i have to try it out myself first i just bought a 92 paseo
185/60R14
2.0470" - 2.0463" (51.003 mm -51.997 mm).
replace the break light switch located under the dash on the brake pedal arm. It has a clip on the side the pulls out and then a pin that comes out.
the Toyota kind! just kidding! trans fluid is just hydralic fluid. dexron 3 will work fine.
If you have tilt steering, there should be a switch or little pull lever on the left side of the steering wheel, but i havent had a tilt in any of my Paseo's xP