Put your seat belt on. if that doesn't work (i suspect if you're asking that it doesn't) the problem is either in the drivers seatbelt receiver, which has a switch that turns the light off when you put the belt in it, or the retractor which has a sensor for the same purpose. you can turn the light off by finding out which is bad and replacing it.
under the drivers seat.
i have 98 prizm lsi, same problem. just pull the seat belt a little farther the warning light should go off.
wear a seat belt.
Until the seat belt is buckled.
Yes.
That light will go out as soon as you fasten every seat belt in the car.
Put your seat belt on.
The passenger side seat belt light typically stays off if the seat is unoccupied or if the seat belt is not engaged. Most vehicles are designed to detect the presence of a passenger through weight sensors in the seat, which triggers the light when the seat is occupied but the seat belt is unbuckled. If the light remains off even when someone is seated, it could indicate a malfunction in the sensor system.
To turn off the seat belt chime in a 2007 RAV4, you typically need to buckle and unbuckle the seat belt several times while the ignition is in the "on" position. Start by buckling the driver's seat belt, then unbuckle it, and repeat this process three times. After the third time, you should hear a confirmation chime indicating that the feature is disabled. Always consult your vehicle's owner manual for specific instructions, as the process may vary slightly by model and year.
the receiver for the belt has a sensor. if it fails the light will continue to flash even though the belt is buckled. replace it!
It's normal for the light to come then go out. It's part of the start-up diagnostic, checking all systems. However if the light comes on and stays on even after you have put your seat belt on then you could have a problem.
by putting you're seat belt on?....