Toggle the POWER button to the left of the gear shifter.
According to the repair manual: Remove the grommet from the speedometer and turn off the lamp by pushing the warning light reset switch, then replace the grommet.
To reset the timing belt light on a Toyota Land Cruiser, first turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. Turn the ignition off, then start the engine to check if the light has been reset. If the light remains on, you may need to consult the owner's manual or a professional for further assistance.
To turn off the rear differential light on a 1999 Toyota Land Cruiser, first ensure that the vehicle is in a safe location and the engine is running. Then, check for any underlying issues, such as low differential fluid or a faulty sensor, and address them if necessary. If the light persists after resolving any mechanical issues, disconnect the vehicle's battery for a few minutes to reset the system. Reconnect the battery, and the light should turn off if there are no remaining issues.
To reset the timing light on a 1997 Toyota Land Cruiser with a 1HZ engine, first, ensure the engine is at operating temperature. Disconnect the timing light's power and connect the inductive pick-up around the number one spark plug wire. Then, locate the timing adjustment screw on the distributor and turn it to the specified timing mark on the engine's timing cover. Finally, reconnect the timing light and check the timing against the manufacturer's specifications.
According to the repair manual: Remove the grommet from the speedometer and turn off the lamp by pushing the warning light reset switch, then replace the grommet.
1. Change your filter 2. With the key off unplug the wires on top of the filter housing 3. Turn key on then plug wires back in 4. Turn key off then start car.
press and hold trip odometer button. Put in key an turn to accessory. Light eill flash then go out.
It is the combination turn signal, high beam, head light switch.
Turn ignition on disconnect wires on top of fuel filter housing, leave for 10 seconds, replug together wires, turn off ignition.light should now be reset
On the turn signal lever next to the headlamps switch. It's the one that controls the dashboard light brightness
The fog light switch is on the end of the turn signal switch. Just pull the end of the turn signal switch and the fog lights will come on. (Turn signal switch and fog light switch are one assembly)
To reset the timing belt light on a Toyota Land Cruiser, first, turn the ignition key to the "on" position without starting the engine. Then, press the gas pedal three times within five seconds. Finally, turn off the ignition and start the engine to check if the light has reset. If necessary, repeat the process to ensure it has been cleared.