124 mph electronically governed
Acura Integra GS-R was created in 1992.
The manual that came with my 1990 Acura Integra GS indicates to use Dexron II. If you change the fluid only it's 3.2 qts. I hope this answers your question.
1/2 drive Ratchet
jump a hot wire downt to it with it running with gauges on it and read the readings.
97 acura integra had 140hp but the gs-r has 170hp and the type r has 190hp
It doesn't have one.
The fuel filter on a Acura Integra is located near the rear of the engine. More specifically it is mounted on the firewall of the engine bay.
A 1990 Acura Integra GS with an automatic transmission typically uses Honda ATF-Z1 (or its equivalent). It's important to avoid using other types of transmission fluids, as they may not provide the necessary performance and protection for the transmission. Always consult the owner's manual for the most accurate information regarding fluid specifications.
On a 1990 Acura Integra GS, the crankshaft position sensor is typically located on the engine block, near the front of the engine, close to the crankshaft pulley. It may be mounted on the timing cover or near the oil pan. To access it, you might need to remove some components for better visibility. Always refer to a service manual for detailed instructions specific to your vehicle.
Cause it's not American. Buy a proper car!.... EH...WRONG! My 1990 Integra GS is doing this so I tested it, and it was throwing a code 9 which ir cylinder position sensor. Have you tested yours yet?
Should be located inside transmission pan.
RS, LS, GS: 126 lbs-ft. @ 5000 rpm GS-R: 117 lbs-ft. @ 7000 rpm per Acura