On a 1995 non turbo Eclipse there are 2. One is at the front end of the car right off the exhaust manifold and the other which is on the long pipe just after the catalytic converter.
The 2001 Mitsubishi Eclipse GT with a 3.0L V6 engine typically has four oxygen sensors. There are two upstream (pre-catalytic converter) sensors and two downstream (post-catalytic converter) sensors. These sensors help monitor the air-fuel mixture and ensure proper emissions control.
You can find them in the exhaust pipe. Depending on engine size you might have anywhere from 2 to 4 oxygen sensors.
The cost of an oxygen sensor for a 2000 Mitsubishi Eclipse GT will cost between $55 and $80. The difference depends on location, dealer, and brand of sensor.
4
The 2003 Mitsubishi Eclipse GTS with a 3.0L V6 engine typically has four oxygen (O2) sensors: two upstream (pre-catalytic converter) and two downstream (post-catalytic converter). These sensors monitor the exhaust gases to help optimize fuel efficiency and emissions control. If you're troubleshooting or replacing them, it's important to ensure you have the correct sensors for your specific model and engine configuration.
On a 2008 Mitsubishi Eclipse, the oxygen sensors are located in two main areas: one upstream (pre-catalytic converter) and one downstream (post-catalytic converter). The upstream sensor is typically found on the exhaust manifold or just before the catalytic converter, while the downstream sensor is located after the catalytic converter in the exhaust system. To access them, you may need to lift the vehicle for better visibility and reach.
The 2003 Mitsubishi Eclipse typically has four oxygen sensors: two upstream (pre-catalytic converter) and two downstream (post-catalytic converter). The upstream sensors monitor the oxygen content in the exhaust gases to adjust the air-fuel mixture, while the downstream sensors check the efficiency of the catalytic converter. However, the exact number may vary depending on the engine type and model configuration. Always refer to the specific vehicle’s service manual for accurate information.
i think there is 2
Top of the head
Two, an upstream and a downstream oxygen sensor.
To replace the oxygen sensors on a Mitsubishi 3000GT, first, ensure the vehicle is off and cool. Locate the oxygen sensors, which are usually found on the exhaust manifold and after the catalytic converter. Disconnect the electrical connectors and remove the sensors using an O2 sensor socket or a wrench. Install the new sensors by threading them into place, reconnecting the electrical connectors, and ensuring they are secure.
there should be 2 oxygen sensors, one easily seen just coming off exhaust part of engine and the second one just past catalytic converter.