You can expect a good gain of about 8-10HP and 7-8 FT-LBS of torque...this is average for most vehicles, though for our cobalts because the air intake is in the fender well we notice this much better, also mileage will increase as well
between 10-15 HP
Yes, a cold air intake designed for a Cobalt SS may fit a Cobalt LT, but it's always best to check with the manufacturer or a mechanic to confirm compatibility. Some modifications or adjustments may be necessary for proper installation.
The cold air intake may add 5-10 hp to the 335 it was built with.
By installing an cold air intake on a mustang
A cold air intake will increase your horse power
A quality made cold air intake system will add around 5 h.p.
Cold air intake is better because it's denser.
A cold air intake regulates the amount of cold air coming into a car and ensures the air is properly filtered.
what year
A cold air intake is an aftermarket part used to help open air flow to the engine. The cold air intake sucks up cold air from underneath the car and is attached to your intake manifold. So it is a pipe going from somewhere close to the bottom of the engine compartment leading to your intake manifold.
It depends on the intake that you get. There are short ram air and cold air intakes. Cold air intakes are preferred amongst rsx enthusiasts because of the cold air that is being sucked into the motor. On average, about 3-14 HP can be obtained from an intake. The quality and type of intake is what makes the difference between a lot and a little HP.
You will not damage your engine if you remove its cold air intake. The cold air intake system is merely added to increase engine efficiency and performance.