Head will have to be removed. This is a major repair. As long as you have the head off, you need to have all valves ground and/or replaced. If the engine has over 150,000 miles on it, I would do a complete overhaul at the same time. Removing the head is 75% of the work.
Pull the fuse out and look at it. If you cannot tell by looking if it is burnt or not, then check the continuity with an ohm meter.
More than likely the bulb is burnt out.
If the headlights will not work properly on a 1992 Honda Accord than the fuse may be burnt out. To check the fuse locate it under the hood of the vehicle. The fuse box is behind the battery.
This is an indication you have a bulb burnt out on the side the blinker is blinking real fast.
If your instrument lights have burnt out on your 2000 Honda Accord.... You may have another problem!!! While the dealer fixes this recall, they should replace your burnt out bulbs. 2000 Honda Accord Recall ID from NHTSA: 04V256000 Auto Recall Date: 06/07/2004 Vehicle Component: INTERIOR LIGHTING Estimated Vehicles Affected: 19572 2000 Honda Accord Defect Summary: ON CERTAIN PASSENGER VEHICLES, THE DIMMER CONTROL FOR THE INSTRUMENT PANEL LIGHTS COULD FAIL DUE TO HEAT BUILDUP. Defect Consequence: IF THIS OCCURS, THE INSTRUMENT LIGHTS MAY FAIL AND, AT NIGHT, THE DRIVER MAY NOT BE ABLE TO SEE THE INSTRUMENT PANEL GAUGES, SUCH AS THE SPEEDOMETER. Remedy: DEALERS WILL REPLACE A MULTIPLEX CONTROL UNIT FOR THE INSTRUMENT PANEL LIGHTS. OWNER NOTIFICATION BEGAN JUNE 16, 2004. OWNERS SHOULD CONTACT HONDA AT 1-800-999-1009. Notes: AMERICAN HONDA MOTOR CO., P36
Burnt valve, blown head gasket, hole in piston, severely worn compression rings.
It means the transmission overheated. Have the fluid changed and you may be ok. Then find out why it got too hot.
find the burnt out fuse and replace accordingly with the same or weaker: NEVER stronger.
Happened to my 97 Accord EX. The power window switch for driver's window was burnt. Had to replace entire unit.
Is there a question in all this rambling?
it means your transmission control modular is going out.. to fix it you need a new one. to replace remove carpet on passenger side floor board near transmission. look for a cover plate remove it under it will be a processor that will look burnt remove it replace with new one.
Can be engine miss cause by bad spark plug or plug wire. Can also be a vacuum leak, or a broken motor mount. A burnt valve is also possible.