If you're trying to remove the brake drum, be sure to NOT have the emergancy brake on. Remove the wheel and tap the drum with a rubber mallet until it releases, That's it!
The brake drum cannot fall off unless the wheel is removed. That is physically impossible.
Take the wheel off to see if you see a caliper for a disc brake or a drum for a drum brake.
On a 1997 VW Cabriolet, the rear brake adjustment is typically located at the rear brake drum assembly. You can access it by removing the rear wheel and the brake drum. Inside the drum, you'll find an adjustment wheel or star wheel that can be turned to adjust the brake shoes' position. Make sure to adjust both sides evenly for proper braking performance.
Brake wheel cylinder or axle sealBrake wheel cylinder or axle seal
To adjust the hand brake on the rear drum of a 1995 Renault Clio, first, ensure the vehicle is securely lifted and supported. Remove the rear wheel and the drum to access the brake assembly. Locate the adjusting wheel or screw mechanism inside the drum; turn it to either tighten or loosen the brake shoes until they make slight contact with the drum. Finally, reassemble the drum and wheel, and test the hand brake to ensure it holds the vehicle securely.
what are the pins for on a wheel drum?
Master cylinder or drum brake (hydraulic slave) wheel cylinder or disc brake caliper cylinder? drum brake shoes rear
Brake problem. Remove the rear wheel & brake drum, and inspect the brake components. You may have a leaking wheel cylinder or other problem. Also inspect the wheel bearing.
To remove the rear brake drum from a 2002 Mitsubishi Lancer, start by loosening the lug nuts on the rear wheel and then lift the vehicle and secure it with jack stands. Remove the wheel, then locate the brake drum. If the drum is stuck, tap around the edge with a hammer to loosen it. Finally, pull the drum straight off the hub, ensuring any retaining clips or hardware are removed beforehand.
It is inside the rear brake drums. It is the part that pushes the brake shoes out against the drum.It is inside the rear brake drums. It is the part that pushes the brake shoes out against the drum.
If it is a drum brake system, then you will have to remove the wheel ,drum, brake shoes, and hydraulic brake line , then remove and replace the cylinder with a new one re-assemble and bleed the hydraulic brake system
To remove the rear brake drum from a 1999 Isuzu NPR, first ensure the vehicle is securely lifted and supported on jack stands. Remove the wheel and tire, then locate the retaining bolts or screws on the drum; if present, remove them. If the drum is stuck, tap it gently with a hammer to loosen it, and use a brake adjustment tool to back off the brake shoes by turning the adjuster wheel. Once loose, the drum should slide off the wheel hub.