There is an adjusting bolt on the bottom of the PSP, loss it and push the PSP down,
the remove the belt.............. it will be easy
How do you replace power steering belt on 2003 Mazda protege ?1.6
power steering fluid resivour
Screwed into the side of the power steering pump.
Remove the power steering belt first then the alternator belt will go on.
Right on the power steering pump. pointing to the front of the car.
Check for a loose power steering belt.
This year Mazda protege does not have a serpentine belt. It has two belts, one for the alternator/water pump, and the other for the power steering and a/c.
if you don't know how to do it, hire someone who does. this can be a dangerous procedure, if there is power to the air bag when it is disconnected, it will discharge, it has been know to break unsuspecting necks.
Brake system, low lubricants, excessive wear and tear of power steering system, for starters.
i need to change my alternator belt and don't know where the tension wheel is so i can take off the other belt to replace the alternator belt on my 94 Mazda protege 1.6l
This applies to a 2003 Mazda Protege: It depends on what type of engine you have. For the 1.6L engine, the oil dipstick is the front-passenger side area, close to the power steering reservoir. For the 2.0L engine, the dipstick is on the same side but towards the back, close to the wheel.
Use DEXTRON II. Remove the power steering fluid reservoir cap, and fill the power steering reservoir until the fluid reaches the ''full'' line.