A small dowel or cleaning rod long enough to pass through the drains can push debris out the bottom - they're just tubes that come out underneath the bumper.
On a 1989 Acura Integra hatch back the brake lights are reached through the hatch itself. The brake lights housing are on the rear of the vehicle. Unplug the bulbs and replace them.
The rear hatch can be replaced by another hatch from an 82 to 92 firebird or camaro.
Left the rear hatch and remove the headliner trim and headliner ( Partially). Unplug the brake light wire that leads to the light housing. Loosen 2 screws below the light and remove carefully.
May be a BCM glitch or the rear trunk latch there is a recall from gm about the rear hatch latch
You can not open the rear hatch door from the inside.
what are the wires for on the rear hatch door hydraulic pumps
The back hatch glass hinges are commonly referred to as rear hatch hinges or liftgate hinges. They are the components that allow the rear glass or hatch of a vehicle to pivot or open.
The rear hatch on a 1998 dodge durango won't open
To manually open the rear hatch of a 2002 beetle can be hard depending on weather the hatch is closed or open. If needing to manually open a hatch you will have to take the plastic cover from the inside of the hatch then push the latch open.
The open-close sensor for the rear hatch on a 2000 Subaru Outback Wagon is typically located within the latch assembly of the rear hatch itself. This sensor detects whether the hatch is closed or open and is integrated into the mechanism that secures the hatch when it's closed. If you're troubleshooting, it's often accessible by removing the interior trim panel on the rear hatch.
The emergency rear hatch release for a 2005 Chrysler Pacifica is typically located inside the vehicle, near the rear hatch area. You may find it on the ceiling near the rear hatch or on the side panel near the rear seats. It is usually a pull lever or a button that can be used to manually unlock and open the hatch in case of a power failure. Always refer to the owner’s manual for specific details related to your vehicle.
Remove the plastic molding covering the inside of the rear hatch. The hole located at the bottom of the hatch (long slot) is where you'll need to insert a flat blade screw driver. There is a pivot point that connects both latches through rods (left and right) on the rear hatch. Cause the pivot point to pivot using the flat blade screw driver and push the hatch outward. The rear hatch should now be open.