Get a multi-meter and check for power at the motor that moves the lights up and down. If there is 12V, your motor is shot. If there isn't 12V then it could be a fuse. Use your multi-meter again to check for voltage across the fuse. If there is 12V across the fuse, the fuse is blown. If there is virtually no voltage measured across the fuse, the fuse is good. You might have other problems. Good luck.
You should remain stopped until the bus's red lights are no longer flashing.
Yes you should. The thrust race will run dry and fail.
You should only use your parking lights when your vehicle is parked or when you are stopped in an emergency situation. They should not be used while driving.
the fuse should be labelled tail lights.(whats the problem with no. plate lights?)
Too many. Should have stopped production with one; The Prototype.
When a bus is stopped with its lights blinking, you should come to a complete stop regardless of the direction you're approaching from. This is to ensure the safety of children getting on or off the bus. Only proceed once the lights are off and it is safe to do so. Always be aware of your surroundings and watch for pedestrians.
There should be a diagram on the inside of the fusebox cover.
You should only use your parking lights when your vehicle is parked or stopped in a dark area. They should not be used while driving as they are not bright enough to properly illuminate the road.
Wait for the train to go by or for the lights to turn off.
Hazard lights may only be used during an emergency where the vehicle requires to be stopped in places it should not normally be stopped, such as a highway. People mistakenly used hazard lights when driving through heavy storms as another form to ensure visibility and is not recommended.
If it is the same as the 1993 version, there will be screws/bolts in the back of the bed that you can unscrew/unbolt and u should be able to get at the tail-lights from there.
The brake switch for a Nissan Quest should be under the dash on the brake pedal arm. If the switch goes bad then the brake lights could stay on or not work at all.