1. You may have a break in the line along the wires connected to the Rx side. If at all possible, try a different cable.
2. The Tx part of the equipment on the other end is failing.
3. The Rx light on your smart jack is failing.
If the Tx (Transmit) light on the smart jack is blinking green while the Rx (Receive) light is not illuminated, it suggests that data is being sent from the device but is not being received on the other end. This could indicate a potential issue with the receiving device, such as a faulty connection, configuration error, or the device being powered off. It's also possible that there is a problem with the cabling or network configuration between the two devices. Further troubleshooting would be needed to isolate the exact cause.
It is likely due to faults in your service provider's network.
A red and green blinking light on an ankle monitor typically indicates that the device is in the process of charging or is experiencing connectivity issues. The red light often signifies that the battery is low or that there is a problem with the device, while the green light may indicate that it is functioning properly or connected to the monitoring system. If the blinking continues or if there are concerns, it's advisable to contact the monitoring agency for assistance.
The green power indicator light will keep blinking on and off on a new Comcast HD cable box when it is booting up but cannot detect a signal. A technician may need to be called out to correct the problem.
A Kidde smoke detector blinking a green light typically indicates that the device is functioning properly and is receiving power.
It could be a poorly or improperly terminated ethernet cable. Or the cable length may be too long (you didn't specify)... 100 Meters (about 320 feet) is the maximum for UTP Category 5 cable.
Usually it has a lite with green red and blinking red. Green meand its good if there is no green then its blue. If its red it means it is almost out of battery. But if its blinking red then that means that it's realy close to dead.
off green blinking green
The reason it's blinking green and orange is because it's loading
A cyan colored surface will reflect any blue or green light that is incident. The green filter will remove all colors of light passing through it except green. The book is illuminated with only blue light. Draw your conclusion.
Buy an evo
It means the device is on. I know the device is on and fully charged but the power light should be blinking green not red. Why is the power light blinking red when it should be blinking green??