on the muffler
Yes, there is also the pre cat O2 Sensor which is conveniently located about 6 inches behind the latch to open the hood in the center.
On the 2000 model G20 there is the one in the front on top of your exhaust manifold. It is a three prong sensor
Then there is another four prong sensor right after the exhaust manifold meets the exhaust pipe. Close to the engine. I was told by an Inifiniti mechanic that there are only two on this type of car and indeed there are only two.
I was told by another place that there were four sensors on this car but they were wrong. I know because I ony found two and changed them myself.
When you do change the sensors go to your local auto parts store and have them use an OBD2 device to clear your service engine light and drive the car about 30 miles on the hiway if you can. This will reset your sevice engine light and you are good to go.
i need to locate knock sensor on a 2000 infiniti g20
Bank one sensor two refers to the oxygen sensor. The bank one sensor two oxygen sensor is on the front side of the engine, after the catalytic converter.
in the distributor
located in the distributor
Remove the vacuum hose from the sensor. Pull the sensor out of the air cleaner housing. Insert the new sensor into the air cleaner housing and attach the vacuum hose.
exhaust pipe
On an Infiniti G20, the knock sensor is typically located on the engine block. Specifically, it can often be found near the intake manifold or on the side of the engine, depending on the model year. To access it, you may need to remove some components for better visibility. Always refer to the vehicle's service manual for precise location details and instructions.
R&R tps sensor
Right behind the Cat. toward the back of the car.
How to replace starter on a 95 G20 infiniti?
it not FUSE, ITS A CIRCUIT BREAKER
Yes. The rear bumper cover was the same on the Infiniti G20 from 1999-2002.