is the crankshaft position sensor the same and the engine speed sensor
The crankshaft position sensor on a 2004 Nissan Altima is located near the bottom of the engine, typically on the driver's side. It is mounted on the engine block, close to the crankshaft pulley. To access it, you may need to remove some components, such as the engine cover or other obstructions. Always consult a repair manual for specific instructions and diagrams.
On a 2000 Nissan Altima, the crankshaft position sensor is located near the bottom of the engine, typically at the rear of the engine block, close to the transmission. It is often positioned near the crankshaft pulley or harmonic balancer. To access it, you may need to lift the vehicle and remove any obstructing components. Always consult the vehicle's service manual for specific instructions and diagrams.
A bad crankshaft in a 96 Altima could cause the engine not to start. Depending on the crank damage, the engine could start but not run properly.
the wire connected to the front of the distributo is the crankshaft wire connector follow that wire and it will lead to the crank sensor i believe on the back under the engine
The 2008 Nissan Altima has an inline 4 engine.
The 2010 Nissan Altima has an inline 4 engine.
The 2001 Nissan Altima has an inline 4 engine.
The 2002 Nissan Altima has an inline 4 engine.
The 2004 Nissan Altima has an inline 4 engine.
The 2014 Nissan Altima has an inline 4 engine.
The 2013 Nissan Altima has an inline 4 engine.
The 2006 Nissan Altima has an inline 4 engine.