Yes, the 2001 Toyota Sienna does have an Intake Air Temperature (IAT) sensor. It is typically located in the intake manifold or air intake duct, near the air filter or throttle body. The IAT sensor helps monitor the temperature of the incoming air to optimize engine performance and fuel efficiency.
its is located downstream on the backside exhaust manifold
2002 toyota sienna electroni coil located
The knock sensor on a 2001 Toyota Sienna is typically located on the engine block. Specifically, it can be found on the passenger side, near the rear of the engine, beneath the intake manifold. You may need to remove some components for better access, so consult a repair manual for detailed instructions.
The 2001 Toyota Sienna OBD 2 port is on lower edge of dash; mounted on a bracket above accelerator pedal
The 2001 Toyota Sienna has a V6 engine.
The 2001 Toyota Sienna has 24 valves.
On a 2003 Toyota Sienna, the fuel filter is located in the gas tank. Toyota started putting it there either in 2001 or 2002.
The 2001 Toyota Sienna has a 4-speed automatic.
The 2001 Toyota Sienna is a gas-powered vehicle.
The mass airflow sensor is located on top of the airbox (air filter housing). It has a plug with maybe 6 wires in it and is held in place with 2 Phillips head screws.
The 2001 Toyota Sienna's turning circle is 40 ft..
The 2001 Toyota Sienna is 16 ft. 2.2 in. (194.2 in.) long.