Re-set it for what? If you ran the gas tank dry while the engine was running you ought to be able to re-set the OBD by simply turning the ignition off and then on again. If this does not work you've got a problem that needs a mechanics help.
You have to reset the computer
how to reset display screen after changing oil at 15000 miles. this is on a 2008 highlander.
To reset the oil change light on a Toyota Highlander 2012, switch the engine to the OFF position. Then switch the engine back on while pressing the trip meter reset button until it displays 000000 or says COMPLETE.
I want reset computer avalon 2007 limited
Disconnect both cables on battery, hold horn down for abouta minute, reconnect battery about 15 minutes later
You do not have to reset the computer. It will take care of itself.
If you're looking for an inertia switch for the fuel pump, it doesn't have one.
You do not have to reset the computer any more than you reset your computer in your home after a power outage. It will take care of itself.
Yes, you do... But if you do within 1-2 minutes you might not reset the computer.
On the 08 highlander make sure that your ODO display is on trip A then turn off your key, hold down the trip reset button and with your other hand turn the car to on. the display will flash to a series of either 0's or dashes, they will then countdown to nothing. When the display goes blank the reminder is reset. Since it is reset now do not rely on it for a monitor since it will come on 5k after being reset.
On the 2006 Toyota Highlander, the tire pressure reset button is typically located beneath the steering wheel, near the driver's side dashboard. It may be necessary to look closely, as it can be somewhat hidden. To reset the tire pressure monitoring system, turn the ignition to the "on" position (without starting the engine) and press the reset button until the indicator light blinks three times.
To reset the VSC light on a 2002 Toyota Highlander, first, turn the ignition to the "ON" position without starting the engine. Press the gas pedal to the floor three times within five seconds, then turn the ignition off. Start the engine, and the VSC light should be reset. If the light persists, there may be an underlying issue that needs to be diagnosed.