answersLogoWhite

0

If you are speaking of the PCM(Power Control Module) or ECM(Engine Control Module, it is located in the inside middle of the dash. There is also a ECM relay in the underhood fuse box.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

What is a tcm on the Isuzu Rodeo trans?

TCM= Transmission control module.


Where is the transmission control module on a 1998 Isuzu Rodeo?

The guy at the local transmission repair shop told me it sits on top of the engine control module. You have to remove the console to get to it.


Where is the relay switch for your Isuzu hombre?

My 1997 hombre will not start. How can I tell if it is the relay switches or the control module.


Why do your 2001 Isuzu rodeo intermittent wipers get stuck?

there is a problem with your bcm or body control module, have it checked


Where can you find an engine control module for a 1986 Isuzu trooper?

its under the center console between the seats


Location of a glow plug module in an Isuzu NPR 94?

The glow plug relay is on the drivers side of the truck in a relay box on the chassis frame behind the drivers side tire. which module is it?


Where is the ignition control module 1991 Isuzu rodeo 2.6l?

It is located under intake manifold towards the back. It is above the starter.


Where is the ecm on a 1994 Isuzu Rodeo?

On a 1994 Isuzu Rodeo, the Engine Control Module (ECM) is typically located under the dashboard on the driver's side. It is mounted above the accelerator pedal area, near the steering column. You may need to remove a cover or panel to access it. Always ensure the vehicle is turned off and take necessary precautions when handling electronic components.


What does a crank angle sensor do in a Isuzu trooper?

Assuming you mean crank position sensor, it tells the ignition control module the position of the crankshaft so the module can tell the correct coil to fire at the correct time.


How do you fix a code 37 in an Isuzu Rodeo?

A code 37 on an Isuzu Rodeo means to check the transmission. This could mean that a short is occurring between the Transmission Control Module and the Electronic Computer Unit. Check all wires going from the transmission to the computer. If no short is found, a tube might be placed over the wires to prevent them from accidentally coding for no reason other than magnetic interference.


Where is the flasher location on a Isuzu NPR?

the location is on the left side of glove compartment, but you have to remove it to get threre


Flasher relay location on 2005 Isuzu npr?

flasher relay location on 2002 isuzu npr?