Remove all screws and plugs. You will need a small flathead screwdriver to 'pop' the pin that holds the window winder in place ( behind it) then pull the bottom of the door trim outwards and lift it upwards. wind window all the way down first so not to scratch the glass as you remove the trim.
Using the correct sized screw driver, remove the screws and remove the clips that are in the door panel. Pull the panel away from the frame slowly, remove any wire connectors and then remove the panel from the frame.
Need to know how to remove the interior door panel so I can replace motor for electric window
its called the bumper cover
screws on the inside of the door, almost on bottom
The fuses on an 85 Honda Prelude are located in the panel near the hood release and under the hood. The main fuse box is located against the firewall in the engine compartment.
drivers side under dash mounted in fuse panel
The OBD connector on a 1992 Honda Prelude is located under the dashboard, near the driver's side, typically just above the area where the brake pedal is located. You may need to remove a cover or panel to access it. It's usually a 16-pin connector, which is standard for OBD-I systems.
In the 1992 Honda Prelude, the fuse box is located inside the cabin on the driver's side. You can find it under the dashboard, near the steering column, and it may be necessary to remove a cover panel to access it. Additionally, there is another fuse box located in the engine compartment, near the battery.
Lower dash, driver's side. Behind a panel. LOOK!
When you open the hood, there should be a panel behind/above the light socket, remove that, unplug the light and check the size of the light find the same size and replace it.
To remove the radio from a 1998 Honda Prelude, first disconnect the car battery to prevent any electrical issues. Then, use a flathead screwdriver to carefully pry off the trim panel surrounding the radio. After removing the trim, unscrew the mounting screws holding the radio in place, then gently pull the radio out. Finally, disconnect the wiring harness and antenna cable from the back of the radio.
The diagnostic port on a 2000 Honda Prelude is located under the dashboard on the driver's side. Specifically, it is near the steering column, just above the brake pedal. You may need to remove a cover or panel to access it easily. This port is used for connecting a diagnostic scanner to read trouble codes and perform vehicle diagnostics.