HERE IS THE LOCATION ,USE A SPANNER TO REPLACE IT. https://sites.google.com/site/autobestanswer/toyota
how much engine coolant dosee a 2000 toyota corolla hold
You will have to replace the refrigerant, but not the engine coolant.
To replace the coolant temperature sensor on a 2000 Toyota Corolla, first ensure the engine is cool and disconnect the negative battery terminal. Locate the coolant temperature sensor, which is usually near the thermostat housing or engine block, and disconnect the electrical connector. Use a socket to unscrew the old sensor and replace it with the new one, tightening it securely. Reconnect the electrical connector and the battery terminal, then check for leaks and ensure the engine runs properly.
engine coolant temp sensor.
To replace the thermostat in a 2000 Toyota Avalon, first, ensure the engine is cool and disconnect the negative battery cable. Drain the coolant, then remove the upper radiator hose connected to the thermostat housing. Unbolt the thermostat housing, replace the old thermostat with the new one, and reassemble by tightening the housing and reconnecting the hose. Finally, refill the coolant, start the engine, and check for leaks.
It is possible that a check engine light on a Toyota Highlander will come on if the coolant level is low. Usually, though, there is another light that will come on that says 'low coolant' on some older Toyota's.
Any brand coolant will work.
Well, honey, the coolant temperature sensor on a 1995 Toyota Tercel is usually located near the thermostat housing or on the cylinder head. To replace it, first, make sure the engine is cool, then disconnect the electrical connector, unscrew the sensor using a wrench, apply some thread sealant on the new sensor, and install it in the same location. Don't forget to reconnect the electrical connector and refill the coolant if needed. Good luck, darling!
To replace the thermostat on a 1999 Toyota Solara, first ensure the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator, then locate the thermostat housing, typically attached to the engine with bolts. Remove the housing, take out the old thermostat, and clean the mating surfaces. Install the new thermostat with the spring side facing the engine, reattach the housing, refill the coolant, and reconnect the battery.
in the radiator, some in the engine and some in the reservoir
Open the drain out valve at the bottom of the radiator to allow the coolant to run out. Replace the valve and add the fresh coolant.