Does it Flash on 12
2005 Nissan Sentra 1.5 S: Press and hold the Clock button on the radio. When the hour numbers start flashing, *press the UP or DOWN arrows until the correct hour is displayed. Press the CLOCK button again and the minutes will start flashing. Repeat from * to set the minutes. Press the CLOCK button again to exit the clock setup function.
To set the time on a 1990 300zx clock, first, press and hold the "clock" button until you see the hour digits blinking. Use the "tune" knob to set the correct hour. Press the "clock" button again to make the minute digits blink, and use the "tune" knob once again to adjust the minutes. Finally, press the "clock" button one more time to save the new time setting.
To set the clock on a 2002 Nissan Quest, turn on the ignition without starting the engine. Press the "Clock" button on the audio system or dashboard until the hour digits begin to blink. Use the "Seek" or "Tune" buttons to adjust the hour, then press the "Clock" button again to set the minutes, repeating the same adjustment process. Finally, press the "Clock" button one more time to save the settings.
You need to turn off the radio and then turn it back on while holding down the clock button from there use the up and down buttons to change hour then press clock again and use the up and down buttons to change the minutes then turn off the radio. When you turn the radio on again the clock should be working
You need to turn off the radio and then turn it back on while holding down the clock button from there use the up and down buttons to change hour then press clock again and use the up and down buttons to change the minutes then turn off the radio. When you turn the radio on again the clock should be working
The cost of a Nissan Sentra clock varies slightly by the year of the car and retailer. As of 2014 the clocks range in price of 24.99 to 49.99.
To change the time on the clock in a Nissan Pulsar N16 series, first, turn on the ignition without starting the engine. Press and hold the "Clock" or "Set" button until the time display starts to blink. Use the "Hour" and "Minute" buttons to adjust the time, then press the "Clock" or "Set" button again to save the settings. Finally, ensure the display shows the correct time before turning off the ignition.
On the Dashboard Under Your Speedometer
Press and hold the clock button for at least 2 seconds. The hours on the clock will flash. Use either the Tune/FF-REv or Seek/Track button up or down arrow to adjust the hour up or down. Press the clock button again and the minutes on the display will start flashing. Repeat the process. When the clock has been set, press clock again and it will return (stop flashing.) It will return to normal clock display in 10 seconds, or you can press clock one more time and it will return to the regular display setting. These instructions are right out of the owner's manual.
Twist the thing on the dash.
Clock operationPressing the CLOCK button displays the clockwith the radio on or off. Press the CLOCK buttonagain to turn off the clock display.Clock set1. Press and hold the CLOCK button for approximately2 seconds.2. The display will show “H-Seek M-Tune”.3. Press the SEEK/TRACK buttonor to adjust the hours.4. Press TUNE/FF·REW buttonor to adjust the minutes.5. Press the CLOCK button again to exit theclock set mode.The display will return to the regular clock displayafter 10 seconds, or you may press the CLOCKbutton again to return to the regular clock display.http://www.altimacoupe.com/download/08-coupe-OM.pdf
Use the clock on the aftermarket stereo that you should buy. My clock on my 92 always gets off so i just use the clock on my stereo.