answersLogoWhite

0

Sometimes an electronically controlled (or manually for that matter) mirror will become displaced due to a bump on the housing, which allows a certain amount of movement. This is so the mirror doesn't get snapped off if it gets bumped.

When this happens the control mechanism at the back of the mirror is dislodged and must be coaxed back into place, it's not too difficult, just have a good look at it and work out what you need to do.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you intall brake light switch for 2001 daewoo nubira?

http://wiki.answers.com/Q/How_do_you_intall_break_light_switch_for_2001_daewoo_nubira"


Where is the sports mode switch on a daewoo nubira cdx?

Most likely on the gear shift under the handle on the righthand side.


Where is the fuel cut off switch in a daewoo nubira?

Well, isn't that a happy little question you've got there! In a Daewoo Nubira, the fuel cut off switch is typically located in the trunk, behind the carpeting on the left side. Remember, it's important to stay calm and patient when handling these things, just like when we're painting happy little trees.


Where is daewoo nubira fuel pump reset switch located?

its between the driver seat and the door jam on the floor beside the seat


Where is the reverse switch Daewoo Nubira?

Looking from front of car to engine look just behind headlamp on top of gearbox and theres a two pin plug connected to switch which screws into gearbox housing


I have a 1999 daewoo nubria all the windows work but the drivers side window?

It's possibly the switch or the motor in the door. I have a 99 Nubira (Australia) and the window winder motor died. I got a 2nd hand/used one with the assembly and swapped it. Now it works fine! Jeff in Oz


Where do i get parts to fix electric window on passenger side of 2001 daewoo nubira since it won't go up?

Replace the rocker switch unit in the door. Usually about $10-$15 from wreckers. Common effect is window will go down but no up...(Burnout of switch unit.) Will master on drivers door work window?? If yes, then above is the problem...


Where is the brake light switch on a 98 daewoo nubira?

The brake light switch on a 1998 Daewoo Nubira is typically located near the top of the brake pedal assembly. It is mounted on the bracket that holds the brake pedal in place, and it activates the brake lights when the pedal is pressed. You may need to remove some cover panels under the dashboard for better access. If you're having trouble finding it, consulting the vehicle's service manual can provide more specific guidance.


On a 1997 Daewoo Nubira the brake lights are not working but the central LED one is you have checked the fuses and changed the bulbs any ideas?

possible turn signal switch failure common on gm cars


When the brake lights still do not work after installing a new stop light switch does the switch need to be adjusted or should you adjust the brake pedal on a 2000 Daewoo Nubira?

i believe you need to buy a comlete new break switch.if the lever on the break switch is vertical to the floor,i think it might be bad.


A rear window defogger switch for a 2000 daewoo nubirta?

The rear window defogger switch for a 2000 Daewoo Nubira is typically located on the center console or dashboard, often near the climate control system. This switch activates the rear defogger, which uses electrical heating elements in the rear windshield to clear fog or ice. If the switch is malfunctioning, it may require replacement or repair, which can often be done by consulting the vehicle's service manual or a certified mechanic.


Why headlights and fog ligts on my daewoo nubira went out?

The headlights and fog lights on your Daewoo Nubira may have gone out due to several potential issues, such as blown fuses, burnt-out bulbs, or a malfunctioning headlight switch. It's also possible that there could be a wiring problem or a failure in the vehicle's electrical system. To diagnose the issue, check the fuses and bulbs first, and if those are fine, consider consulting a mechanic for a more thorough inspection.