kick it
which pully do i remove tension to remove the alternator?
On mine there was a hole going back under the button. I had to insert a very small screwdriver into the hole and and push it all the way back and put pressure against a piece of metal that was holding tension on the button keeping it in. I was then able to push the button out while holding pressure against the back of the hole.
press the eject button
First you will need to loosen the tension on the belt in order to remove the belt. After that, you will need to remove the bolt holding on the alternator. Installation is the reverse. Dont forget to tension the belt
You can bypass the AC low pressure switch, on your Toyota Corolla, by removing the switch. You can remove the wiring to the switch and leave the switch and place.
The reset button for tire pressure is with the fuses on the passenger side of dash. Remove plastic fuse cover and you will see red reset button. Good Luck!
The air conditioner low pressure switch in a 1993 Toyota SR5 is behind the glove box. There are three screws inside the glove box to remove for access.
all u have to do push to light towards the font bumper pressure is required
To remove the fan belts from a Toyota Condor, first, ensure the engine is off and cool for safety. Loosen the tensioner pulley by turning the adjustment bolt counterclockwise, which will relieve tension on the belt. Once the tension is released, slide the belt off the pulleys. If necessary, consult the vehicle's service manual for specific instructions related to your model.
There should be a lock on the ignition a push button that you push and turn to remove the key
unbolt the negative power wire unplug the positive power wore remove the tension bolt on the top of the alternator remove the lower bolt and pull out the alternator
The tension pulley on a 2004 Toyota Highlander is located on the front of the engine, typically near the serpentine belt. It is part of the belt tensioning system and helps maintain the proper tension on the serpentine belt that drives various accessories. To access it, you may need to remove some engine covers or components, depending on the specific engine configuration.