answersLogoWhite

0

1st stage 22 lbft. 2nd stage 43lbft. 3rd stage 65lbft. 4th stage loosen 90degrees then torque to 65lbft. 5th stage run engine to hot then allow to cool for at least 4 hrs. 6th stage loosen 90degrees then torque to 65lbft


Torque for Daewoo Cielo 1.5 l engine I hope it will be the same for matiz 1. 25 nm 2. + 60 degrees 3. + 60 degrees 4. + 30 degrees 5. + 30 degrees with hot


User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Torque settings for megane 1600 k4m?

torque settings for cylinder head bolts


What are the cylinder head torque settings for a Mazda bongo 2.5 turbo diesel 1997?

what are the torque for camshaft and cylinder head bolts please


What are the torque settings for the cylinder head bolts on a daewoo matiz 800?

The torque settings for the cylinder head bolts on a Daewoo Matiz 800 are typically around 20 Nm (15 lb-ft) for the initial pass, followed by a further tightening to 90° for the final pass. It's important to follow the specific sequence for tightening to ensure even pressure across the cylinder head. Always consult the vehicle's service manual for the most accurate and detailed specifications.


What are the cylinder head bolt torque settings on an Isuzu kb 250 4ja engine?

What are cylinder head bolts torque settings for Isuzu kb240. Engine NAQ001716


Cylinder head torque wrench settings for 1600 Ford Escort?

Get a manual on your car and it will give you the settings of the intake, exhaust bolts plus the head bolts and torque pattern.


Head bolts torque settings?

hi i am looking for the torque settings for a proton gen 2 cylinder head bolt and crank shaft bolts both big ends and main bearing bolts


What is the torque settings on a 1997 daewoo cielo?

The torque settings for a 1997 Daewoo Cielo can vary depending on the specific component being worked on. For example, the cylinder head bolts typically require a torque setting of around 70 Nm (51 lb-ft). It's essential to consult the vehicle's service manual for accurate specifications for each component to ensure proper assembly and prevent damage.


The torque settings for the cylinder head bolts on a daewoo nubira?

In four stages, 1st with a torque wrench then with an angular torque gauge. Note: when replacing the head gasket, you should replace the head bolts as well.25 n/m (18 lb/ft) + 70 degrees + 70 degrees + 50 degreesin my original daewoo manual says 25n/m +90 degrees+90 degrees+90 degrees daewoo nubira 2.0 2001


Cylinder head torue settings for daewoo tacuma?

The cylinder head torque settings for a Daewoo Tacuma typically require the bolts to be tightened to 30 Nm (22 lb-ft) for the initial stage, followed by an additional 90 degrees for the final torque. It's important to follow the specific sequence provided in the service manual to ensure even pressure across the cylinder head. Always consult the vehicle’s service manual for the most accurate and detailed specifications.


1300 endura e cylinder head torque settings?

The cylinder had bolt torque specification is 90 pounds. The cylinder head bolts should be torqued in 30 pound intervals.


What are the cylinder head torque settings for a Volkswagen lupo?

torue sylinder head bolts volkswagen lupo


Torque settings for citroen saxo cylinder head bolts?

in sequence torque bolts to 20nm, then again in sequence turn a futher 120 degrees, and again in sequence 120 degrees.