The brake light staying on indicates a problem with the brake system, usually low fluid. Check the brake fluid and if it is low, then look for a possible leak in the system or worn brake pads as the fluid had to go down for a reason
The brake light failure sensor on a 1997 Acura 2.2 cl is located on the rear of the car. It is on the back of the left rear lamp assembly.
The brake lights are located in the trunk of a 1997 Acura Integra. To replace them open the trunk and find the plastic housing. Remove and replace the bulbs.
In a 1997 Acura CL, the brake light fuse is located in the under-hood fuse box. To access it, open the hood and locate the fuse box, which is near the battery. The specific fuse for the brake lights is usually labeled on the diagram found on the cover of the fuse box. If the brake lights are not functioning, check this fuse to see if it needs to be replaced.
i have an acura 1997 rl and the tcs light on. what can i do?
When break lights do not turn off when the brake pedal is fully retracted suggests two possible causes: * The brake light switch is out of adjustment and needs to be adjusted. * The brake light switch is defective and needs to be replaced.
I'd check the sensor for the emergency brake. It's probably faulty.
The 1997 Pontiac brake light fuse is located in the fuse box. The brake light fuse will be labeled as the tail light fuse.
On the brake pedal.
The red brake light on the dash means that the brake fluid is low or the parking brake is on.
Yes.
Brake light fuse
insufficient vacuum. The vacuum is part of the brake booster. First thing to check is a defective or leaking hose in the brake vacuum system.