answersLogoWhite

0

The Nissan Maxima code P1131 indicates a problem with the air-fuel mixture, specifically that the engine control module (ECM) has detected a lean condition in the fuel system. This typically means that the engine is receiving too much air or not enough fuel, which can be caused by issues like a faulty mass air flow sensor, vacuum leaks, or fuel delivery problems. Addressing this code usually involves diagnosing the fuel system and air intake components to restore the proper air-fuel balance.

User Avatar

AnswerBot

4mo ago

What else can I help you with?

Trending Questions
Where is the fuel tank pressure sensor located on a 2005 suzuki xl7? How much water can a 1996 Nissan altima radiator hold? How does the Shift Lock in a 1991 Honda Accord work Doesn't seem to matter if I insert the key or not Every time I put the car in park running or not I can't get it to shift out of park Many times? My 1990 Mitsubishi montero runs for a few seconds and then dies..what do i do? How do you change my water pump in Honda Odyssey? How do you drain the gas tank on a 1989 Honda CRX si? How do you replace dash bulbs in 98 Camry Climate Control Panel? How do you clean a throttle body on a 2002 Camry? Where is the fuel level sensor located on a 1999 Subaru Forester? How do you change the starter in a 2001 Toyota Corlla? How do you replace the windshield washer motor on a 1992 Nissan Stanza XE with a 5speed tran and a 2.4 liter motor? What is the percent of water in kiwi? How do you replace expansion valve on a 1994 Camry? Is there a kill switch on a Toyota Echo? Where can you find the size of the brakes pad for the 2002 Toyota Sequoia? What does it mean when the maintenance required light comes on in a 1999 Honda Accord? How do you remove the factory stereo from 2007 Toyota Avalon? What is a good price for a 2004 Subaru Impreza WRX STI? What does it mean when there is no voltage on the alternator line of a '92 integra? How can you get your rear door to open with the door handle on a Honda civic dx 4 door. I can't seem to get the lever inside the panel to connect to the handle.?