answersLogoWhite

0

The type of engine under the hood. Well known for blowing head gaskets.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you replace the transmission fluid in a 1990 Toyota Cressida with a 22r Engine?

Are you sure of the engine size? Should be 7mge inline six cyl. 22r wasn't offered in a 1990 cressida.


What engines can fit in 89 Toyota Cressida?

7MGE, 7MGTE 100% bolt on and it's look to be pretty bolt on to put a 1jz or 2jz engine.


Where can you find the location of knock sensor in a 1992 Toyota Cressida?

If you have the 7MGE engine: Then the knock sensor is screwed into the engine block, directly underneath the intake manifold.


Where do each of the vacuum hoses go on a 1991 Toyota Cressida?

Cressida was only made from '77 to 80, so you don't have a cressida if it's a 91.


What is the best Toyota Cressida engine?

the 7mge is the best all round engine for performance the 5mge is better for reliabilty but if u put a 1jz-gte engine in it u will have a very reliable and powerfull car


When was Cressida cressida created?

Toyota Cressida was created in 1976.


Why the rpm is low about 400-500 rpm in morning after warm up 1100 rpm in cressida 92 7mge?

any answer .......


Can you use the distributor from a 7mgte Toyota supra engine on a 7mge engine?

7mgte doesnt have a distributor. it has coil packs. only 7mge has distributor


How do you change a starter on a 1988 Toyota Cressida?

Change a starter on a 1988 Toyota Cressida


How do you take off engine wiring harness from a 91 Toyota cressida?

There are six steps on how to take off the engine wiring harness on a 91 Toyota Cressida. Some of the step-by-step instructions are disconnect and remove the battery, remove the old harness, and use a small screwdriver to remove the clips and retainers that hold the harness in place.


Where is the starter on a 1984 cressida?

Seek around the flywheel, The Flywheel is between engine and transmission. The starter is probably under the intake like the 7MGE.


Where is the oil pressure switch on a 1991 cressida 6-cylinder?

On a 7MGE it is located to the right of the oil filter above the dip stick tube