Having sold and installed many clutches, I have learned not to use an rebuilt or remanufactured clutch. I would only use a NEW aftermarket or original equipment clutch regardless of brand name. Toyota buys their component parts from vendors so often the aftermarket item is the exact same clutch you would buy if you got it right from Toyota. I hope this helps a little. Mark
figured it out. thanks anyways.
when it slips or grinds
i used to have one of these however I upgraded but before doing so I did have to replace the clutch as my lil bro wore mine out I tried a clutch from a rotary Honda that didnt even fit in however I got in touch with Toyota and they sent me a clutch from a 1998 Toyota tacoma 4x4 it worked until it broke and I needed a new one
My 1997 3.4L 4x4 tacoma has struts but some may have springs My 1997 3.4L 4x4 tacoma has struts but some may have springs
No.
If both are 4X4 then yes.
I am trying to find out the vacum hoses that lead from the power steering pump on my Toyota tacoma 4x4 2.7
Xtreme 4x4 - 2001 Trekking Tacoma Part I was released on: USA: 9 February 2013
The slave cylinder is located on the driver side of your bell housing going to your motor. Its a cylinder about the size of a roll of quarters.. maybe a little bigger.
They both do.
the best way to "bleed" any clutch is to get a can with a pump and a hose that will fit over the bleed screw. Loosen the bleed screw put the hose over it and pump fluid back up to the master cylinder this will force any air out.
It is important to know where to add the proper fluids in a car. A person can add transmission fluid into the transmission dipstick tube of a 1999 Tacoma 4x4.