answersLogoWhite

0

it sends like a message to the computer telling the car when to switch gears. When that goes out u probably only have the set gears below drive.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What if your 2006 suzuki boulevard m50 will just click whenever you try to start it what is wrong with it?

Could be a dead battery or a problem with the starter...most likely the solenoid switch.


Where is the reverse solenoid switch located on a 1997 Nissan Maximum?

The 1997 Nissan Maxima. Reverse solenoid switch is located on the starter. The solenoid switch is attached to the side of the starter.


Why does a 1996 Ford Ranger XLT 4.0L start when you cross the posts on its solenoid but not when you turn the key in the ignition?

the solenoid itself is probably bad, if not that probably the ignition switch I agree 100%, check the solenoid first then the switch.


Where is the solenoid switch on the jeep 2002 SUV?

The starter solenoid is on the starter. Transmission solenoid is in or on the transmission.


Where is the vacuum switch solenoid on your 2001 blazer It works with the air pump.?

The 2001 Chevy Blazer vacuum switch solenoid can be found on the firewall in the engine compartment. The vacuum switch solenoid will be on the passenger side of the firewall.


Where Suzuki quad runner 300 neutral switch?

where is the neutral switch 1998 Suzuki king quad


Where is the solenoid switch located on a 92 dodge ram van?

The starter solenoid is on the starter.The starter solenoid is on the starter.


What does P1776 and P0700 for a 2003 Chrysler town and country?

Code P1776 means "A/T Solenoid switch valve latched in the Low/Rev position" and Code P0700 means "Automatic Transmission Control System Malfunction"


What is a switch that begins with sole?

You have to be more specific to get the right answer


How do you wire a solenoid switch on a Mercury Ford Topaz?

The wiring of the solenoid will depend on what purpose the solenoid serves and the brand. In basic terms, when power is turned onto the solenoid, the inner coil pulls the plunger. The unit needs power and a ground, with a switch or relay to trigger it.


Why doesn't my 65 fairlane turn the motor with the switch I need to jump start from solenoid. I has new solenoid and switch.?

Did you replace the ignition switch? Not the key tumbler but the actual ignition switch. If so, you have a wiring problem.


Why wont the engine shut off on your 1995 ford ranger?

I'm not a mechanic / technician but I'm guessing a starter relay ( solenoid ) malfunction ( located near your battery ) or a problem with the ignition switch Anybody else have any ides ?