To be very simple, there is no cable linking the injection/carburator , your gas pedal is control electronically thus replacing the cable usually linking the injection throttle, (e-throttle)
To replace the throttle body sensor on a 1995 E-150 van, first disconnect the negative battery terminal for safety. Remove the air intake duct to access the throttle body, then disconnect the electrical connector from the throttle position sensor. Unscrew the sensor from the throttle body and replace it with the new one, ensuring it's properly aligned. Reconnect the electrical connector, reattach the air intake duct, and reconnect the battery.
When purchasing a full throttle e-bike, consider the battery capacity for longer rides, motor power for speed and performance, frame material for durability, suspension for comfort, and braking system for safety.
I think it's electronic throttle control.
Trouble code P2125 means: Throttle/Pedal Position Sensor/Switch ""E"" Circuit I would replace the throttle position sensor
The point midway from no throttle to full throttle.
It is on the throttle body.It is on the throttle body.
It is on the throttle body.It is on the throttle body.
The throttle position sensor is on the throttle shaft, on the throttle body.
Assuming you are asking about the throttle position sensor it is mounted on the throttle body and is operated by the throttle shaft.
The throttle position sensor is located on the throttle body. If you follow the throttle cables to the throttle body the TPS will be on the oposite side of the throttle body as the cables attach to.
full throttle
The throttle position sensor is located on the throttle body at the end of the throttle shaft.