the RPM should idle 700 - 900
clean or replace your idle air control valve.
The idle speed for a 2000 Toyota Celica typically ranges between 600 to 800 RPM when the engine is warm. This can vary slightly depending on the specific engine type and condition. It's essential to refer to the owner's manual or a service guide for precise specifications related to your vehicle model.
you can adjust it via the idle control valve.
You dont , it is adjusted by the ecu and the "Idle speed control Valve" now the idle speed control valve might be stuck , so you can remove it and clean it up with some carb cleaner and wd40 , it is located underneath the throttle body
after the vehicle is warm & at normal operating temperature the idle speed should be 700 rpm +/- 50rpm
You don't. If the idle is not within factory spec there is a problem that needs to be diagnosed, such as the idle speed control unit for example.
Idle speed is controled by the computer, therefore non adjustable.
it is not adjustable it is a drive by wire systemMotor Abbreviation Definitions Idle Speeds (Fuel Injected)Trans.Min. Check Speed RPMMax. Check Speed RPMFootnoteAT610710265MT650750265Note 265: Idle speed is not adjustable.
check your vacuum hoses check your vacuum hoses
To adjust the idle speed on a 1997 Toyota Tercel, first ensure the engine is at normal operating temperature. Locate the idle adjustment screw on the throttle body, which is usually near the throttle linkage. Turning the screw clockwise will increase the idle speed, while counterclockwise will decrease it. After making adjustments, check the idle speed with a tachometer to ensure it falls within the manufacturer’s recommended range.
The proper idle speed for a 2000 Nissan Frontier V6 is between 700 rpmÊand 800 rpmÊin park or neutral. In gear, the idle speed should be between 650 rpm and 700 rpm.