0
What else can I help you with?
What is the proper torque for lug nuts on 2008 Honda accord?
80 ft/lbs
What is the proper lug nut torque for a 1996 Honda accord ex?
80 ft/lbs
What is the proper lug nut torque for a 2007 Honda Odyssey EX?
Proper lug nut torque spec for 2007 Honda Odyssey
What is the wheel torque on a 2010 Honda Accord?
Lug nut torque is 80 ft/lbs.
What is the torque for lug nuts on 2008 Honda accord?
80 ft/lbs
What is the proper lug nut torque for a 1997 Honda Accord LX?
The proper lug nut torque for a 1997 Honda Accord LX is typically 80 lb-ft (pound-feet). It's important to use a torque wrench to ensure that the lug nuts are tightened evenly and to the correct specification to avoid wheel damage or failure. Always consult the owner's manual or a repair guide for specific details and any updates.
What is the wheel torque on a1995 Honda Accord?
Wheel lug nut torque is 80 lb/ft.
What is the torque setting for a wheel lug nut on a 2003 Honda Accord?
80 ftlbs
What is the torque setting for a wheel lug on a 2005 Honda Accord?
80 lb/ft
What is the proper lug nut torque for a 2011 Honda Accord?
The proper lug nut torque for a 2011 Honda Accord is typically 80 foot-pounds (ft-lbs). It's important to use a torque wrench to ensure that the lug nuts are tightened to the manufacturer's specifications for safety and to prevent damage to the wheel or hub. Always check the vehicle's owner’s manual for the most accurate information, as variations may exist based on specific models or wheel types.
What is the torque specs for the lug nut on a 2009 Honda Accord?
The torque specification for the lug nuts on a 2009 Honda Accord is typically 80 foot-pounds. It's important to use a calibrated torque wrench to ensure proper tightening. Always check your owner's manual or consult a professional for the most accurate information, as specifications may vary based on the model and trim.
Lug nut torque for a 94 accord wagon?
The lug nut torque for a 1994 Honda Accord Wagon is approximately 80 ft pounds. It is important not to over tighten as the studs may break if mishandled.
