answersLogoWhite

0

The coil numbering for the 1994 Isuzu Trooper typically follows a specific sequence related to the ignition system. Generally, the cylinder numbering starts from the front of the engine, with cylinder 1 being on the driver's side, and proceeds to the rear. For the ignition coils, they are usually labeled according to their corresponding cylinder positions, with coil 1 servicing cylinder 1, coil 2 for cylinder 2, and so on. It's important to refer to the vehicle's service manual for precise details and diagrams specific to your model.

User Avatar

AnswerBot

3w ago

What else can I help you with?

Related Questions

Where is the starter located on a 94' Isuzu Trooper?

The starter on a 94 Isuzu Trooper is located on the bottom, passenger side of the vehicle. It is found at the rear of the engine, at the flywheel.


Can you put a manual transmission in a 94 Isuzu Trooper with a auto transmission?

Can I replace my auto transmission with a maual transmission in my 94 trooper


How many quarts of oil does a 94 Isuzu trooper take?

5 with filter change


94 Isuzu Trooper acceleration is sticking and almost caused a wreck what can cause this?

accelerator cable


Where is flasher relay on 94 Isuzu trooper?

its behind the fuse box. you can get to it by looking up from the peddles


Need a diagram for a rear axel on a Isuzu trooper 94 DOHC V6 3.2 4x4?

replace rear axle bearing


What other vehicles have the same egine starter as a 1990 Isuzu trooper 2.8 ltr 4x4 automatic?

89-94 chevy blazer with 2.8


Where is heater core on 94 Isuzu trooper?

It is under the dash in a plastic box. Use your Haynes manual to remove it. Be extra careful when removing the hoses or you'll break the inlet or outlet tubes because they are made of plastic too.


How do you replace clutch on 94 Isuzu trooper?

To replace the clutch on a 1994 Isuzu Trooper, first, disconnect the battery and remove the transmission by unbolting it from the engine and separating it from the transfer case. Next, remove the old clutch assembly, including the pressure plate and flywheel, and clean the mounting surface. Install the new clutch disc and pressure plate, ensuring proper alignment, and then reattach the transmission. Finally, reconnect the battery and test the clutch operation.


94 trooper dying and hard to restart has odor from exhaust?

catalytic converter


What is fuel pressure on 94 trooper?

41 - 46 psi at the fuel rail


Where is the coil wires on a 94 dodge colt 1.5liter?

There is none. The coil is inside the distributor.