The TPS is the Throttle Position Sensor. You can research additional information on a TPS as it is a very general automotive item, but it is mounted with 2 Phillips head screws on the side of the Throttle Body, which is in front of the intake manifold.
The Intake Manifold is the large, cast metal piece on the passenger side of the engine. The Throttle Body is the mechanical piece with the spring-like mechanism between the intake manifold and your black, plastic cross-over pipe.
The TPS is the small, electronic device mounted on the opposite side of the spring mechanism.
These will fail over time and in Miatas, typically exhibit the feeling of fuel cut or instantaneous loss of power while driving.
This information refers to 1990-2005 Miatas.
Will a 1992 mazda miata hardtop fit a 2000 mazda miata?
To replace the throttle position sensor (TPS) on a 1990 Mazda Miata, first, disconnect the negative battery terminal to prevent any electrical issues. Locate the TPS on the throttle body, detach the electrical connector, and remove the two screws holding the sensor in place. Install the new TPS by aligning it properly, securing it with screws, reconnecting the electrical connector, and finally reconnecting the battery. Be sure to check the throttle position and adjust if necessary for proper operation.
yes, the Mazda miata is rear wheel drive
I would suggest the Mazda Miata dealership site which is www.mmmiata.com, another site to try for Mazda Miata parts is www.autopartsdeal.com/Mazda/Miata/parts.html. For used parts you can try www.autoguide.net
There is no fan belt on a Mazda Miata.
A 1999 Mazda Miata requires 4.0 quarts of oil.
You can rent a mazda miata from Zilok ( US.Zilok.com )
Where can you find a diagram for fuse panel in a 2003 Mazda Miata?
The 1992 Mazda Miata is equipped with a non-adjustable steering wheel.
The 2012 Mazda MX-5-Miata has 16 valves.
The 2007 Mazda MX-5-Miata has 16 valves.
The 2010 Mazda MX-5-Miata has 16 valves.