0
What is the best way to clean the connectors on the original wire harness for a 97 Nissan XE 4X4?
The best thing to use for any type electrical connector or relay would be contact cleaner spray. It can be found at any parts house or electrical wharehouse. If you cant find contact cleaner try pure isopropyl rubbing alcohol. Spray contact cleaner on connectors and brush with toothbrush; repeat if neccessary. let dry before re-connecting and starting engine.
What else can I help you with?
What is the best way to clean the connectors of an automotive battery?
Rusted connectors on a vehicle's battery could be the cause of a car that won't start. The process for cleaning these connectors can be detailed in full on wikiHow.
How can you clean the Idle Air Control Valve on a 1998 Nissan Frontier?
how can I clean the Idle Air Control Valve on a 1998 Nissan Frontier
Example sentence using the word harness?
If we can efficiently harness the power of sunlight we would have all the clean energy that we need.
What CAUSES your 1988 Nissan Sentra to cut out?
most likely cause is ignition (plugs,wires,dist cap,rotor) If all is good check the connectors on the throttle body for corrosion buildup (especially the 5 pin for the mass airflow sensor) clean corrosion if necessary. Could also be a faulty distributor. Nissan had distributor problems in the early mid 80s models
How do you clean a fuel filter on Nissan Pulsar n14?
Replace the fuel filter. There is no way to open it and clean it.
Why would a 1990 Nissan Pathfiner be blowing fuel pump fuses?
check the wiring for corrosion at the pump and all the wat to the front of the vehicle for cracks or chaffing. if you find the connectors loose or corroded clean them and using pliers tighten them slightly Pump has locked up. Replace pump.
What may cause a 2001 Isuzu rodeo with 68K miles to stall while driving or at stop light It has done this 3 times in the last month?
other culprits could be - bad intake gasket new or clean EGR clean connections on computer monitoring circuit check battery connectors/charge main wiring harness ground is loose the timing belt needs to be replaced
How can you prevent corrosion in the connectors inside the memory slots on the motherboard?
Clean the module edge connectors with a soft cloth or contact cleaner. Blow or vacuum dust from the memory sockets. Also, to prevent corrosion in the connectors inside the memory slots is by matching tin leads to tin connectors and gold leads to gold connectors to prevent a chemical reaction between the two metals, which can cause corrosion.
What could cause wipers not to work in a Cadillac Seville?
if you look under the radiator fill bottle there should be a small box that has ground connectors in it and is bolted to the inside firewall clean that and see if that helps. might take apart the connector and get some fine sandpaper and clean the connectors. i had same problem.
Why does a display flicker?
There could be a problem with your monitor or cables. Make sure all cable connectors are clean and connected properly.
On a Renault clio what does the airbag light mean?
Under the passenger seat there is a couple of connectors, unplug them and clean with electrical contact spray and WD40, make sure they fit tight. Under the passenger seat there is a couple of connectors, unplug them and clean with electrical contact spray and WD40, make sure they fit tight.
My Headlights burned out when turning the corner. What would cause this?
i don't think it burned out but rather the wiring is loose take and unplug it use a pick or some small tool to clean your connectors and put a little grease on the prons to keep clean plug back in i don't think it burned out but rather the wiring is loose take and unplug it use a pick or some small tool to clean your connectors and put a little grease on the prons to keep clean plug back in
