The red coffee cup indicator lights up if you've been driving without stopping & turning off the engine for a long period of time (I believe 2 hours, but I could be wrong). You can either ignore the warning (not recommended - it just keeps beeping at you), or you can take the suggestion and have a coffee break
Interior light
A Mitsubishi L200 yellow warning light on the dash could mean the ABS is having issues. It is best to check the owner manual for defined warning light meanings.
three gallons
The symbols on the dash board on a Mitsubishi Pajero are all of the warning lights. Some of the lights will include a seat belt light, check engine light and battery light.
take out wrong codes by computer
The red battery warning light is an indication the charging system is not charging. The red water level warning light is an indication additional water is needed.
The amber warning light in a Mitsubishi Carisma indicates a potential issue that requires attention but is not immediately critical. This could relate to various systems, such as the engine, transmission, or emission controls. It's advisable to check the vehicle's manual for specific guidance and to have the car inspected by a mechanic if the warning persists. Ignoring the light could lead to more serious problems down the line.
Low coolant warning
It is a warning light for front brake pad wear. It comes on when there is about 3-4mm of pad material left.
Check engine light refers to the emission system - have vehicle scanned to determine problem
To reset the engine oil amber warning light on a Mitsubishi Canter, first ensure that the engine oil has been changed and the oil level is correct. Next, turn the ignition key to the "ON" position without starting the engine. Press the accelerator pedal three times within ten seconds, then turn off the ignition. This should reset the warning light. If the light remains on, consult the owner's manual or a professional mechanic for further assistance.
To remove the exhaust temperature warning light on a Mitsubishi GTO after fitting a replacement part, first ensure that the new component is properly installed and connected. Next, disconnect the vehicle's battery for about 10-15 minutes to reset the system. Reconnect the battery and start the vehicle to see if the warning light has cleared. If the light persists, check for any lingering error codes with a diagnostic scanner, as there may be additional issues to address.