5.4
the information I have is .8mm electrode gap
Your spark plug gap info should be on a sticker in the engine compartment. On the front clip above the radiator. That's where it is on my 01 impala
From the 98-01 service manual - .03-.04 inch (.8-.9mm)
The correct plug gap for the 94-01 Integra GS-R is .052 inch. As a little added bit of info, the correct plug is a NGK PFR6G-13.
The spark plug gap on a 1992 Honda Accord (DX,LX,EX) is 1.0 - 1.1mm I verified this information today (01-09-2008) for my NGK ZFR6F-11 spark plugs at a Murray's Auto Parts store.
According to the 2001 Ford Taurus Owner Guide : ----------------------------------------------------------------------------------------------- For the 3.0 liter " Vulcan " V6 engine and its flex fuel version ( .042 to .046 inch spark plug gap ) ------------------------------------------------------------------------------------------------ For the 3.0 liter Dual Over Head Cam " Duratec " V6 engine ( .052 to .056 inch spark plug gap ) ------------------------------------------------------------------------------------------------- * confirm with the Vehicle Emissions Control Information ( VECI ) decal located in the front of your engine compartment . It will show the type of spark plugs to use and the spark plug gap
.060 2.3 and 2.4 OHC Engines 95-97 0.060,,, 98-01 0.050
The correct answer is between 38 and 40 (esp if its an '01) No less than 40 and no more than 45.
AnswerMy 01 is .052 look under hood up front should say good luckunder the hood is a sticker on the top panel above your radiator and it will tell you your spark plug gapping and oil type hope this helps
on my 01 kx 250 my plugs are fouling up almost every time i ride...if i change the plug it will run fine but as soon as i turn my bike off and it cools down my plug will die with in seconds of restartin the bike whats the deal?
To change the spark plugs on a 2001 Ford Ranger, first ensure the engine is cool and disconnect the negative battery terminal. Remove the ignition coil or spark plug wires from each spark plug, then use a spark plug socket and ratchet to carefully unscrew the old spark plugs. Before installing the new plugs, check the gap with a gauge and adjust if necessary, then screw them in hand-tight before using the ratchet to secure them. Finally, reconnect the ignition coil or wires and the negative battery terminal.