33 foot pounds
2006 honda odyssey engine oil drain plug torque
The correct tightening torque for a 1990 Honda Accord oil drain plug is 29 foot pounds. This same torque applies to all Honda oil drain plugs.
it is next to where to mount the oil filter. it is either 17mm or 19mm with 58 lb torque
The engine oil drain plug torque spec is 19 Ft-lbs.
29 ft/lbs
where is the coolant drain plug on the engine block of Honda ACCORD 2.4 2006
Some torque converters have a drain plug on them. Remove the rubber plug from the bottom of the bell housing. Crank engine a little at a time until the torque converter drain plug can be seen from the bottom. Unscrew the drain plug and drain the fluid. Put the plug back in.
For a 2003 Honda Element EX with rear 4-wheel drive, the torque specifications for the rear axle components typically range from 33 to 47 lb-ft for the wheel lug nuts. Additionally, if you're working on the rear differential, the drain and fill plug torque specs are usually around 33 lb-ft. Always consult the vehicle's service manual for the most accurate and specific torque values.
The drain bolt in under at the rear of the engine.
The 1999 Honda Accord air conditioning drain to can be located on the bottom of the air conditioner compressor. The drain to allows condensation to drain on the ground below the engine.
27 foot pounds
The oil drain plug is located on the bottom of the engine on the oil pan. Remove with 17mm wrench and tighten to 10 Lb/Ft torque and no more. The radiator drain plug is located on the bottom of the radiator. If you can't find it simply remove the lower radiator hose to drain the radiator.