For a 1998 Mitsubishi Mirage, the torque sequence for the head gasket typically follows a specific pattern to ensure even pressure. Start by tightening the head bolts in the sequence recommended by the manufacturer, which usually involves tightening from the center outwards in a crisscross pattern. The initial torque is usually set between 22-25 ft-lbs, followed by a final pass at around 44-48 ft-lbs. Always refer to the vehicle's service manual for the exact specifications and sequence for your specific engine variant.
Do you mean the radio unlock code? If you do, it is 4893 for my daughter's 2001 Mitsubishi Mirage.
How to replace wiper motor on a 1998 montero sport mitsubishi
hi fireing order for a 1.5l is 1-3-4-2
Were is the oil pressure sending unit on a 95 mitsubishi miaage
i need the torque sequence for a 1998 pontiac grand am 2.4 quad
passenger side front bumper
Buy thre Haynes repair manual for $19.99!!
The clutch slave cylinder in your 1998 Mitsubishi does not use fluid. The clutch slave cylinder is sealed with grease inside of it.
A 1998 Mitsubishi Mirage with an automatic transmission typically requires about 6 to 7 quarts of transmission fluid for a complete fill, including the torque converter. However, the exact amount may vary slightly depending on the specific model and whether you're doing a fluid change or a complete overhaul. Always check the owner’s manual or consult a professional for precise specifications.
You don't. Just buy a new filter that will have good threads.
Dextron/Mercon III will work for that transmission