0
To remove the spark plugs from a 1991 Toyota Pickup, you typically need a 5/8-inch spark plug socket. It's important to use a socket that has a rubber insert or a magnetic feature to help grip the spark plug securely. Additionally, a ratchet and extension may be necessary to reach the spark plugs easily. Always consult the vehicle's manual for any specific details related to your model.
What else can I help you with?
How do you change wheel bearings on a 1991 Toyota pickup 2WD?
A wrench
What wrench is used to remove 2007 RAV4 oil filter?
In order to remove the oil filter from a 2007 Toyota RAV4 you need to use an oil filter wrench. This wrench is a specialty to Toyota.
How do you tighten a rear transmission mounting bolt on a 86 Toyota pickup?
An impact wrench works good.
What size tool fits transmission filler plugs on 1994 Toyota pickup 5 speed manual transmission?
21mm socket or wrench
How do you replace the oil filter on a 1997 Nissan pickup?
get aoil filter wrench and remove and put new one on.
How do you remove the front bumper on a 1989 Toyota 4x4 pickup?
The front bumper bolts directly to the factory mounts on the frame. You need to remove four bolts, two on each side. Use a 14 mm socket wrench. The bolts are parallel to the ground and perpendicular to the center of the vehicle.
What size wrench is needed to remove a caliper bolt on a 1999 Toyota Corolla?
14 mm
How do you remove the timing chain on the R22 engine 4 cylinder on a Toyota truck?
with a wrench or socket
How to replace sparkplugs in a 3.9 ford freestyle?
Use a spark plug wrench?
What size wrench is needed to remove the automatic transmission drain plug on 2001 Toyota RAV4?
14mm
What size of wrench do you need to remove the plug in the oil pan to change the oil on a 5.3 LT 2002 GMC Sierra pickup?
It should take a 15mm box wrench to do the job.
How do you remove you joint on Toyota pick up?
To remove the joint on a Toyota pickup, first, safely lift and secure the vehicle. Then, disconnect the battery and remove the wheel for better access. Use a socket or wrench to detach the bolts securing the joint, and if applicable, gently tap with a hammer to loosen it. Finally, carefully pull the joint from its housing, ensuring to check for any additional retaining clips or components that may need to be removed.
