0
What is wrong the upper brake light works but the lower left and right do not all the fuses are good?
Take a 12 volt circuit tester and check the power at the light sockets to see if there is power to them. It may be bulbs or corrosion, so clean the sockets with a fine sand paper. 90% of the time the problem is at the socket or bulb. If this vehicle has a tailer connector on it, BE SURE to check it also for broken wires and corrosion..1930fcoupe
What else can I help you with?
Where is the fuse on a 1972 Mustang?
All the fuses were located at the right of the steering column on the lower right flange of the brake pedal support bracket.
On a 2005 Toyota 4Runner why would the right turn signal and brake light not work but the tail light works?
Have you checked the fuses or bulbs?
No power to green trailer wire?
That should be the right side brake and signal light circuit. Start with checking the fuses. Need more info to help you.
What fuse controls the brake lights on a 96 crown Victoria All lights and turn signals work except no brake lights when brake pedal is pushed?
If all the fuses are good, then most likely the brake light switch right on the brake pedal inside the car. Check that.
2003 Dodge Ram 1500 and the left brake light will not work you have changed the bulb and checked the fuses all are good The right brake light works fine What else could be the problem?
compare the bulb make sure it is the right number bulb or check inside the sucket and see if the connection are not damage or get a test light to see if there is power comming to the back when the brake is depress
Right side brake light and turn signal work left side nothing works and neither running light works?
Start with checking the bulbs, then the fuses. In most vehicles the brake lights and siganal lights and running lights are separate circuits. If the fuses and bulbs check okay check the wiring feeding the rear of vehicle.
Why would the right rear brake light not work when the fuses and bulbs are good on a 2004 Dodge 2500 diesel pickup?
it is a break in the wiring harness take a lead from the other side to connect to the light
How do you replace rear brake light on 1992 Nissan Sentra?
for the 3rd brake light removal, push the lower right side of the plastic housing to the left and easily push up. it will come right out, before pulling completely out disconnect the quick connect by sqeezing tab...
Why would the brake lights tail lights and turn signals not work on your 1985 Volvo 240 if emergency flashers are operational and fuses and bulbs are good?
I am having the same trouble. My brake lights work with the light switch for nighttime driving, but only far right brake light works when i pres brake pedal. Reverse lights dont work at all. Turn signals and hazard light work.
Fuses are good still no brake lights 1996 Chrysler Sebring?
Check bulbs Check stop light switch Also make sure you have the right bulbs model 2057 bulbs.
After replacing the fuses bulbs and brake light switch the tail and brake lights work and then fuse blows 97 Chevy PU?
If memory serves me right, each tail light assembly has a printed circuit board that the bulbs plug into. That circuit board burns out. That part is available from the Chevy dealer.
How do you change the brake light switch on a 1995 Chevy G20?
your in luck i just had to do this on my 95 lol you will have to carefully lower your steering column, and above it there is the brake light switch conected to the brake pedal and a rod going towards the front of the vehicle where the master cylindar is at. on the little piece sticking out to the right of the brake light switch there is a pin that keeps it in place. remove that pin and then remove the wires connected to the switch. should come right off and then just put the new brake light switch on and reverse the steps. hope this helps
