0
In a 1998 Nissan 200SX, the tail lights may stay on due to a faulty light switch, a malfunctioning brake light switch, or a wiring issue that creates a short circuit. Additionally, a stuck relay or a problem with the body control module could cause the lights to remain illuminated. It's important to inspect these components to diagnose and resolve the issue effectively.
What else can I help you with?
How much horsepower does a 1998 200sx Nissan have?
134
What are the mileage intervals to change the timing belt on a 1998 Nissan 1998 Nissan 200sx?
== == 100,000 miles
Where can you get a vacuum hose routing diagram fr a 1998 Nissan 200sx se-r?
You can get a vacuum hose routing diagram for a 1998 Nissan 200SX SE-R from the dealership. You can also order one from the auto parts store.
Where is the ecu located in the 1998 Nissan 200sx se-r?
Behind the radio mounted to the floor board and firewall
Where is the started located on a 1998 Nissan 200sx?
mine is a 2.0L and starter is under the intake manifold....hope that helps
Where is the pull lever to pop open gas tank on a 1998 Nissan 200sx?
On the floor between driverside seat and door.
Where is the knock sensor located at in a 1998 Nissan 200sx?
In a 1998 Nissan 200SX, the knock sensor is typically located on the engine block, near the cylinder head. Specifically, it can be found on the underside of the intake manifold, usually on the driver's side. Accessing it may require removing some components, such as the intake manifold, to reach the sensor.
Where is the oil filter located on a 1998 Nissan 200SX?
I got a 1997 Nissan 200sx and I don't think its that much diffrent. On mine I had to lift it because you cant see it from just opening the hood. Its on the passengers side, facing the firewall. its really hidden in there. And its kind of hard to take it of.
What type of steering fluid for 1998 Nissan 200sx?
For a 1998 Nissan 200SX, you should use power steering fluid that meets the specifications of Nissan's PSF (Power Steering Fluid). Typically, this would be a Dexron III or equivalent automatic transmission fluid. Always check your owner's manual for the most accurate recommendations. Additionally, ensure the fluid is at the proper level and condition for optimal steering performance.
Where is the starter located on a 1998 Nissan 200sx manual transmission?
I just replaced the starter on my 1998 200sx SE-R. You have to remove the intake manifold, and you will see it right under/behind there. You may as well replace the knock sensor while you are in there. About a 2 hour job altogether.
You have 1998 Nissan 200sx you put new starter in it and new ignition wiring harness in and it just makes a click noise from the fuse box on the inside of the car and it wont even start?
You either have a low battery or your terminals need cleaned
Fuse panel diagram for 1998 Nissan maxima?
need fuse location for rear lights for a 1998 Maxima
