answersLogoWhite

0

5W30 or 10W30 of any major brand .

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How gain access to the sunroof motor on 2001 Nissan Pathfinder?

where is the location of lelay for 01 nissan pathfinder moonroof


Is 20w50 good 01 Nissan Pathfinder?

no it`s a bit thick and will make your mpg less


Could a bad transfer case on a 01 Nissan pathfinder se 5speed damage the rear differential?

it could but is not likely to the transfer case transfers power to the front diff, not the rear


How much oil does a Nissan Xterra 01 take?

If it is a V6 it will take 3.5 quarts with a new filter.


How do you change the oil pump on a 2001 Nissan Altima GXE?

if my oil pump went on my 01 altima is it worth fixin or do you think the engine is shot


What type of oil is used in 01 Jeep Wrangler?

10w30


How do you remove the ignition rotor screw on a 1995 Nissan Pathfinder?

the d6p84-01 v6, and the d4p84-04 four cylinder engine distributors on 1986 and newer pathfinders cannot be rebuilt. if there is a problem then the whole assembly must be replaced.


What type of oil does a Mercury Cougar 01 use?

5W30 full synthetic.


Where is bank 1 02 sensor 2 located on a 01 pathfinder?

its on the passenger side rear one.


My 2001 Nissan Pathfinder's Idle is going up and down 1100 to 3000?

I'm in the same boat with my 01 Pathfinder and the most likely answer is the Idle Air Control Valve or IACV. The question we haven't solved is why the valve isn't working. By all accounts the IACV is a very solid part on the Pathfinder. The dealership wants me to replace the valve and possibly the ECM also. The valve is about $400 but the ECM is closer to $1300. A second shop said the problem was wiring. I don't have the final answer but would like to hear any feedback you have


Fork oil capacity for 2003 Yamaha TTR250?

Lance's Haynes manual says: Capacity: 555cc, Type: Yamaha fork oil "01" or equivalent


How do you remove front parking light assembly on 1999 Nissan Pathfinder?

There is a male/female push clip on bottom right. Spray WD40 liberally and push in and pull out repeatedly to lubricate the clip and it should eventually let loose. Mine is a 2000 model but I think 99 and 01 is the same.