answersLogoWhite

0

HI,

Compression should be 128 to 156 psi, with no more than 14 psi. difference between cylinders.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you replace the transmission fluid in a 1990 Toyota Cressida with a 22r Engine?

Are you sure of the engine size? Should be 7mge inline six cyl. 22r wasn't offered in a 1990 cressida.


Where is the thermostat located on a 1985 Toyota Cressida?

Should be in a removable housing at the engine end of the upper radiator hose


What is the gas for 1989 Toyota cressida?

I figure you mean what grade of gas should I put in my cressida? Before I blew my headgasket, my 89 cress took 91 octane, anything else would cause piston knock. [detonation]


What should the tire pressure be on a 2005 Toyota Highlander 2 wheel drive?

The tire pressure in a 2005 Toyota Highlander should be about 35 pounds. This model has a low pressure indicator alarm.


Where is the fuel pressure regulator on the engine of a 1995 Toyota 4 Runner?

What should the fuel pressure be for a 1993 toyota 4 runner?


Would a 1999 Toyota Camry transmission fit a 1999 Toyota Camry?

Both cars should have same kind of engine: either 4 cylinder or 6 cylinder.


How do you check spark in a Toyota Cressida 1986?

Disconnect a sparkplug wire or 2 and ground it to the engine and crank engine over-you should get a snapping blue spark


How often should you replace the timing belt on a 1998 4-cylinder Toyota Camry?

Toyota recommends every 90K.


How do you calculate volume after some pressure is released from cylinder?

The volume should not change if the cylinder is rigid.


What is the Cylinder pressure for 1979 350 engine?

a strong engine should read between 150 and 180 pounds of pressure in each cylinder.


How many degree should you put timing mark for 89 Toyota Cressida?

For a 1989 Toyota Cressida, the timing mark should be set to 10 degrees BTDC (Before Top Dead Center) when using a timing light. Ensure the engine is at normal operating temperature and the timing is adjusted with the vacuum advance hose disconnected and plugged. Always consult the vehicle's service manual for specific details and procedures.


Where can I find a rear axel for a 1989 Toyota Cressida passenger side?

Check directly below the trunk. It should have two wheels/tires attached. No charge, you're welcome.