0
What else can I help you with?
94 Toyota Camry loud noise from exhaust manifold?
manifold or downpipe gaskets may be leaking gases or worse, cracked manifold
How much does it cost to a cracked exhaust manifold in a 1002 Toyota Camery?
Nothing. There were no Toyota Camery's or any other kind of car for that matter in 1002!
What is the Location of oxygen sensor in a 1992 Toyota truck?
The exhaust manifold
To replace a starter on a 97 Toyota 4 runner do you have to remove the exhaust manifold?
No you do not have to remove manifold. It is a tight fit to get starter out and then back in again,,,have patience and play the wiggle game,,g luck have fun.
How many oxygen sensor does Toyota Celica has?
Yes, one O2 sensor and it's on the exhaust manifold. It has two nuts that hold it on and has a connector which unplugs to replace it.
Where is the oxygen sensor located in a 1986 Toyota Cressida?
below exhaust manifold... left hand side... were the manifold joins into 1 pipe becoming the exhaust
Where is 02 sensor located on 1993 Toyota Paseo?
it's in the down pipe coming from your exhaust manifold. you will have to remove the heat shield from the exhaust manifold to access it
Where is coolant temperature sensor located on a 2001 Toyota RAV4?
The coolant temperature sensor on a 2001 Toyota RAV4 is located on the exhaust manifold. It is on the driver's side of the manifold.
Where is the bank1 sensor 1 o2 sensor on a v6 2000 Toyota tundra?
Left side (drivers side) exhaust manifold. Between the exhaust manifold and catalytic converter
Where are the O2 sensors in a Toyota runx rsi?
they are on your exhaust manifold, just before the silencer
Where is the oil filter on a 2003 highlander Toyota?
front of engine under exhaust manifold
Where is the O2 sensor located on a 1992 Toyota Paseo?
The oxygen sensor is located in the exhaust manifold before the catalytic convertor. If you look down between the radiator and the exhaust manifold a few inches before the exhaust pipe connects to the exhaust manifold you will see the Oxygen sensor. The sensor will have 2 wires coming from it and it kinda looks like a sparkplug stuck into the exhaust manifold. There is 2 nuts that hold the oxygen sensor into the exhaust manifold.
