answersLogoWhite

0

no fluid in reservoir due to leaking reservoir or slave cylinder

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How does a clutch break work?

If a truck has a clutch brake it would only be used when coming to a complete stop. By pushing the clutch peddle completely to the floor you would apply the clutch brake. This stops the clutch disc from spinning making it easier to shift into 1st or reverse gear. Normal shifting while driving you would not need to or want to push the clutch peddle to the floor to activate the clutch brake.


Why would the clutch pedal on a 1986 Toyota Corolla go all the way to the floor and the car cannot shift into gear.?

It sounds like the clutch master cylinder or slave cylinder has gone bad.These are not that expensive to replace.


Which would have greater acceleration if the same force was applied to a Semi Truck or a Toyota?

The Toyota would have more acceleration a= F/m if the mass of the of the Semi Truck is greater than the mass of the Toyota.


How do you adjust a clutch on a 1984 4x4 Toyota truckWhat would make the clutch stay to the floor on a 1984 4x4 Toyota truck?

Well your clutch should be a hydraulic clutch system and if your pedal is stuck on the floor that would mean that there is possibly no fluid in your reservoir. The system might also need to be bled. To do this you need to fill your reservoir with fluid (brake fluid). Your reservoir is located on the left side of your brake master cylinder. On the right side of the transmission you will see your slave cylinder for your clutch. It will have a hard hydraulic line going into it, (looks like a brake line), and on that slave cylinder there is a little nipple that you can put a 8mm wrench on. Okay now for the bleeding process. You will need a buddy for this. Have your buddy sit in the driver seat and hold the clutch to the floor. When he has it all the way to the floor, open up that nipple and let the fluid, (or air), out. When the pressure slows tighten the nipple back up. Have your buddy let the clutch back out and repeat the process until you dont have any air coming out of that nipple. Should look like a solid stream of fluid with no bubbles. You may have to fill your reservoir half way through the process.


Where can one purchase floor mats that would fit in a Toyota Tacoma?

One can purchase floor mats that would fit in a Toyota Tacoma by going to the Carid website. Also, AutoAnything and Amazon sell Toyota Tacoma floor mats too.


What is wrong when the clutch goes all the way to the floor very easily?

I would say air in the line, or you need a new clutch


Would the clutch pedal going to the floor and staying on the floor be just the clutch going out or what could it be if so and how do you replace the clutch on a 2001 Maxima?

You should not attempt to replace the clutch yourself unless you have considerable mechanical skills. In this case, the problem is most likely that the spring holding the clutch pedal in place is broken.


92 Toyota Ex cab truck clutch sticking on the floor when pressed suggestions?

First make sure the pedal itself is not getting hung up on anything, ie. the floormat, or the carpet. Next if you look where the pedal mounts to the firewall of the truck there should be a return spring that reaches from the framework of the mounting setup for the pedals to the pedal itself. If that is in place then you must address a hydraulic issue. Make sure the slave cylinder mounted on the transmission is extending properly when clutch is depressed. If the slave cylinder does not, the master cylinder, a broken line, or the slave cylinder itself would be the culprit. If the the slave cylinder checks out, try putting the vehicle in gear with the clutch stuck down. If you can do so without your foot on the clutch I would think the throwout bearing/pressure plate assembly is binding and not forcing the clutch fork back to return the clutch. If this is the case then you're looking at a clutch replacement.


Is the clutch in a 1995 Toyota Celica adjustable?

The clutch in a 1995 Toyota Celica is not adjustable in the traditional sense. It uses a hydraulic clutch system that automatically self-adjusts as the clutch wears. If you're experiencing issues with the clutch, it may be due to wear on the clutch components or hydraulic system problems, which would require inspection or replacement rather than adjustment.


94 Toyota truck transmission work in a 86 Toyota truck?

A manual can; an automatic will not, as the 94 transmission will be electronically controlled, whereas the 86 would be mechanically controlled.


On a 1990 Isuzu Amigo what would cause the clutch pedal to stick to the floor?

if its hydraulic there could be air in your line. bleed your clutch and refill.


What would it cost to replace the clutch on a 1993 Toyota Camry?

The estimated cost for parts and labor to replace the clutch on a 1993 Toyota Camry is between $1,260 and $1,687. This can be higher or lower depending on where a person lives.

Trending Questions
How do you tighten the rearview mirror on a 1999 I30 infiniti? Does a 94 Honda civic ex have a cable or hydro clutch? How do you replace the expansion valve on a 1986 300zx Nissan and also what do you have to do to replace the condenser I put a new drier and compressor in my car But guess it has some trash in it.? Where do you add transmission fluid to a 2002 Isuzu Rodeo? What type of Oil does a 97 Nissan Maxima need? How can you test a specific fuel injector on a 1992 300ZX? What type of shocks for Toyota matrix? Does a 1997 Nissan Sentra come with power steering? Donde consigo un aro dentado para una Nissan Stanza 86? Where is the fuel filter located in a 2003 Hyundai Tiburon GT and how can you replace it. the fuel pump was taken out of the gas tank and there was no filter? How do you change oil pan gasketon a 2002 Lexus es 300? Where exactly is the fuel pump located on a 1995 AWD 1.8L Subaru Impreza? Does the 2003 Mitsubishi Lancer OZ Ralley use wheel bearings on the front as you were told by your mechanic that you need to replace one? Where is the turn signal harness location on a 02 infiniti qx4? How do you change the oil pump on a 94 Accord LX? What is the wheel bolt pattern for a 2007 Hyundai Tiburon? Where can you find engine parts manual for 1995 Nissan pickup? What does it mean when VSA light switch on in 2006 honda accord 2006 model? I just bought a 1999 acura 3.2tl and it died while i was doing 60 mph on the freeway the engine just quit does anyone know what the issue is could it be the ecu or the fuel pump relay? 2009 Toyota Corolla serpentine belt noises?