answersLogoWhite

0

It's definitely not in the Instrument Cluster, since I disconnected it to replace some lamps and then reconnected it and the data was there again (unless there is a extremely long lasting - since mine is already 12 years old)

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

2001 Jeep Wrangler Sahara wondering how to fix my non-working speedometer?

What is not working about the speedometer cluster? Wrangler speedometer clusters use LED lights and the speedometer is electronically powered, no mechanical cable. Replace cluster if reason for speedometer not working is in the cluster. Check to see if speed sensor is bad before replacing cluster. On wranglers, mileage on salvage clusters may not matter because the computer on the wrangler stores mileage and mileage normally reverts back to mileage in computer. Replacing cluster requires a two out of five level of knowledge. Short 3 to 4 inch and long Philips screw driver and patience is all that should be needed to do the job. After removing screws, be careful not to break clips on molding that help hold cluster in place. Do not attempt to replace LED lights, if this is the problem. Ebay has these clusters for around $85 plus shipping of approximately $15. Hope this answer helps.


How do you reset error code on the computer on 1995 Mazda 626LX 2.0 LTR with manual transmission?

un hook the negative battery cable and hold your foot on the break for 30 secons and it will reset your computer


How many gallons of gas does a 1992 Mazda B2200 hold?

The 1992 Mazda B2200 will hold close to 17 gallons of gas. The 1992 Mazda B2200 is a four-cylinder vehicle.


How do you reset trip mileage on 2016 c4 grand Picasso located next to cars mileage?

To reset the trip mileage on a 2016 Citroën C4 Grand Picasso, locate the trip computer button on the dashboard or the steering wheel controls. Press and hold the button until the trip mileage resets to zero. Ensure the vehicle is in the "on" or "run" position, but the engine does not need to be running while you perform this action.


What uses a shared storage medium to hold application data?

A failover cluster.


How can you change the speedometer of a Mazda rx8 from miles to kilometers?

To change the speedometer of a Mazda RX-8 from miles to kilometers, start by turning on the ignition without starting the engine. Then, press and hold the trip odometer reset button located on the instrument cluster. While holding the button, turn the ignition off and then back on, continuing to hold the button until the display changes from miles to kilometers. Release the button, and the speedometer should now reflect kilometers.


What exactly is the hold on a 1993 Mazda protege how do you stop it from blinking?

== ==


What hold the Virgo cluster together?

The gravitational pull of its members and dark matter


How much oil does a 1994 Mazda 323 hold?

two gallons


How can you reset the serviec computer system when you cheng the microfilter in new bmw5 series2004?

this should of been done by your dealer if you still under the maintence program. however if you do it yourself its fairly easy. first turn the car on and the key to position two, then hold down the trip button in your instrument cluster down, hold it until a little red microfilter symbol appears in the middle of you cluster, let go of the button and press and hold it again. then a reset will appear in the cluster. let go and push the button again. this should reset it. check in your service data through the i drive and verify it did reset. turn off the car and your done.


How many suitcases does a Mazda 6 hold?

A butt load! considering I have the 6i hatchback it can easily hold 6.


Remove the instrument panel from a seat leon?

Pull steering wheel out and dow towards the floor. Pull out corrugated plastic in front of cluster. Two screws hold in the cluster, remove them. Pull out cluster and release two connectors from the back.